RADVision VIU-323 User Manual

Also see for VIU-323: Quick start

Contents

user guide
Table Of Contents
Table Of Contents
Table Of Contents
Table Of Contents
Table Of Contents
about this user guide
Introducing the
Introducing the VIU-323
VIU-323 Physical Description
Rear Panel
The OnLAN 323 Product Series
OnLAN 323 Product Collaboration
VIU-323 and MCU-323
An Introduction to H.323
Package Contents
Physical Location
Power Connection
LAN Connection
Connecting to the Console Port
Next Step: Configuration
Planning the Configuration
Configuration PC Requirements
Navigating the Configuration Software Screens
Configuration Checklist
Selecting the VIU-323 for Configuration
Figure 7 - Configuration Source screen
Figure 8 - Software Version screen
Figure 9 - Change Password screen
Figure 10 - Source list of configuration files for VIU-323 configuration parameters
Setting Unit Identification Parameters
Setting Network Parameters
Setting LAN Port Parameters
Setting Dialing Parameters
Saving VIU-323 Configuration Parameters
Figure 15 - Save Setup screen
After Configuration
Setting up a Call
Basic Dialing
Changing Outgoing Bandwidth
Why Change the Default Outgoing Bandwidth?
Dialing Examples
Changing Incoming Bandwidth
Why Change the Default Incoming Bandwidth of the Remote VIU-323?
Changing Both Incoming and Outgoing Bandwidth
Upgrading the
Upgrading the VIU-323 Software
Uploading the New VIU-323 Software Version
Monitoring the
Monitoring the VIU-323
Prerequisites
Modem Connection
LED Indications
Analyzing Problems
Verify Component Interactions
Network Problems
IP Address Problems
RJ-45 LAN Port
RS-232 9-pin Male Connector Pin-Out
Null Modem Cable
Figure 20 - Null modem cable
DCE Mode V.35/RS-366 Y-Cable
Safety Considerations
IP Addressing Scheme
Subnets and Using a Subnet Mask
Hexadecimal Notation
Interfaces
Environmental Requirements

RADVision VIU-323 User Manual Manual pdf 47 page image

Selecting the VIU-323 for Configuration5-3" To change the IP address of a new VIU–3231. Type the IP address you want to assign in the Unit IP text box. The LANconfiguration station broadcasts the new IP address. The VIU-323 changes its IPaddress to the broadcast IP, and restarts with its new IP address and the EnterPassword screen is displayed.2. If you selected a unit from the Unit IP list, click Next to display the Enter Passwordscreen.Figure 7 - Configuration Source screenConfiguration Source Screen ParametersThe upper area of Configuration Source screen contains the following read-onlyparameters:Unit Type – displays the type of RADVision unit you selected for configuration.Hardware Version – displays the hardware version of the selected unit.

/ 129

This manual is suitable for:

VIU-323

manualsdatabase

Your AI-powered manual search engine