Tips and Troubleshooting9-6IP Address ProblemsIf you experience difficulty setting the VIU-323 IP address parameters (IP address, defaultrouter IP address and IP subnet mask) using the OnLAN Config 323 system configurationsoftware, an alternate method is to connect the configuration PC to the VIU-323 console(serial) port and run a terminal session. After the terminal session, run OnLAN Config 323to define the other VIU-323 parameters.Defining IP Addresses via a Terminal Session" To establish a terminal session between a PC and the VIU-323Note: The VIU-323 and configuration PC do not have to be disconnected from the LAN.1. Make sure the VIU-323 is turned off.2. Connect the 9-pin male connector of the null modem cable to the console (serial) porton the front panel of the VIU-323 and connect the cable’s nine-pin female connector tothe configuration PC’s COM 1 port (alternately, you can connect the cable’s 25-pinmale connector to the PC’s COM 2 port, but this may require a female/female adapter).3. Use Windows HyperTerminal™ or a similar application to open a console session. Setthe following parameters for Windows HyperTerminal:! Port Settings:Rate=9600Data bits=8Parity=noneStop bits=1Flow control=none! Properties:Function, arrow, and Ctrl keys act as=Terminal keysEmulation=ANSIBackscroll buffer lines=500! Terminal Setup:Underline=enabledBlink=enabled! ASCII Setup:Wrap lines that exceed terminal width=enabled
