Selecting the VIU-323 for Configuration5-11Setting Dialing ParametersIn the Dialing Parameters screen, type the 2nd number delimiter and the default bandwidth.Figure 14 - Dialing Parameters screenThe Dialing Parameters screen displays the following parameters:Physical STD – displays the data interface standard, which is V.35.Dialing STD – displays the dialing standard, which is RS366.2nd Number Delimiter – for use with two-channel (2B) calls only. Options are asterisk (*),pound (#) or None. This delimiter must match the 2nd Number delimiter defined for thegateway. This delimiter differentiates between the two telephone numbers used to dial two-channel (2B) calls (note that if the phone number is the same for both channels, type thephone number once followed by the delimiter). We recommend setting the 2nd NumberDelimiter as * because the VIU-323’s dialing prefix delimiter is preset as #.Codec Type – displays the communications standard used by the room system the VIU-323is connected to; this value is always H.320 and cannot be changed.Outgoing Default Bandwidth – displays the default bandwidth of calls made from theroom system (via the VIU-323). You can change this setting when dialing by adding aprefix to the dialing stream; see “Making Calls with the VIU-323.”Incoming Default Bandwidth – displays the default bandwidth of calls received by theroom system (via the VIU-323). Remote VIU-323’s that call into the VIU-323 can force this
