Using the TV’s FeaturesChapter 3 37Ch 88 -888 WLPJ Cable Input4:3 Normal 480i SDListening to English in SRSMPAA - Not Rated6060 - 2Digital or Analog TV ChannelsA single off-air antenna can pick up both analog and digital channels. Digital channels can bemade up of primary channels and subchannels.Note: Subchannels (sometimes called minor channels) are channels associated with thePrimary channel (sometimes called the major channel). A primary channel may have justone subchannel or multiple subchannels.Direct Tuning to a Channel1. Make sure the remote is in TV mode by pressing TV on the remotecontrol.2. Enter the primary channel number. This number appears in theprimary channel entry box. Press OK or wait a few seconds. Ifyou don’t enter a subchannel, the TV tunes to the lowest digitalsubchannel.3. If the primary channel number has fewer than six digits (for cable), ortwo digits (for antenna) and you want to enter subchannel numbers,press the right arrow button to advance to the subchannel entry box.4. Enter the number of the subchannel. This number appears in thesubchannel entry box.5. Press OK to tune to the channel or wait a few seconds and the TVtunes to the channel.Notes: You can always use the channel up and down buttons onthe remote control to change channels within the TV mode.If you wait too long before entering the subchannel, the TV tunesto the lowest digital subchannel.TipIf a digital and analog channel have the same primarychannel number, tune to the analog channel by enter-ing the analog channel number or entering the analogchannel number and then a subchannel of “0.”PrimaryChannelSubchannel(if necessary)TVON•OFFAUX•HDDVD SAT•CABLEGUIDEGO BACKCH+CH-VOLVOLFORMATMUTEINFOMENU CLEARSKIP1 2 3VCRAUDIOOKBACKLIGHTTV buttonRight arrowTip:Use the channel banner to determinewhether a channel is digital or analog.A digital (ATSC or QAM) channel mayhave a dash and second number afterit (e.g., 21-1); an analog channel (NTSC)doesn’t (e.g., Ch 21).