RCA HD52W56 User Manual

Also see for HD52W56: Technical specifications

Contents

Chapter 2 23Using the Remote ControlUsing Direct Entry1. Turn on the component you want to operate (VCR, DVD player, etc.)2. Look up the brand and code number(s) for the component on the code list in this section.3. Press and hold the component button you want to program on the remote.4. Enter the 4-digit code from the remote control code list on the following pages. If theindicator flashes, you have either entered an invalid code or the button isn’t programmable.5. Release the component button, point the remote at the component, and then press ON•OFFto see if the component responds to the command. If it doesn’t, try pressing the componentbutton and then ON•OFF again.• If you get no response, repeat these steps using the next code listed for your brand, until thecomponent responds to the remote commands.• If you try all the codes for your component brand and none work, try the automatic codesearch method. If automatic code search doesn’t find the code, the remote is not compatiblewith your component.How to Use the Remote After You’veProgrammed ItBecause this remote can control several different components (TV, DVD, VCR, satellite receiver,etc.), it uses operational modes triggered by the component buttons.1. Press the appropriate component button (DVD or AUX) to set the remote to control thecomponent.2. Press ON•OFF to turn the component ON or OFF.3. Use the remote buttons that apply to that component.Notes: The remote control may not be compatible with all brands and models ofcomponents.If you keep pressing buttons and nothing happens, the remote is probably in the wrongmode. You must press the component button that matches the component you want tooperate (i.e., if you want to operate the DVD player, press DVD on the remote control to putthe remote in DVD mode.)