Using the TV’s FeaturesChapter 3 29Ch 88 -888 WLPJ Cable Input4:3 Normal 480i SDListening to StereoMPAA - Not Rated6060 - 2Digital or Analog TV ChannelsA single off-air antenna can pick up both analog and digital channels. Digital channels can bemade up of primary channels and subchannels.Note: Subchannels (sometimes called minor channels) are channels associated with thePrimary channel (sometimes called the major channel). A primary channel may have justone subchannel or multiple subchannels.Direct Tuning to a Channel1. Make sure the remote is in TV mode by pressing TV on the remotecontrol.2. Enter the primary channel number. This number appears in theprimary channel entry box. Press OK or wait a few seconds. If youdon’t enter a subchannel, the TV tunes to the lowest digitalsubchannel.3. If the primary channel number has fewer than six digits (for cable) ortwo digits (for antenna) and you want to enter subchannel numbers,press the right arrow button to advance to the subchannel entry box.4. Enter the number of the subchannel. This number appears in thesubchannel entry box.5. Press OK to tune to the channel or wait a few seconds and the TVtunes to the channel.Notes: You can always use the channel up and down buttons onthe remote control to change channels within the TV mode.If you wait too long before entering the subchannel, the TV tunesto the lowest digital subchannel.TipIf a digital and analog channel have the same primarychannel number, tune to the analog channel byentering the analog channel number or entering theanalog channel number and then a subchannel of “0.”PrimaryChannelSubchannel(if necessary)DVD ON OFFAUX TVVOLMUTE GO BACKCHCLEAR MENUOKOKTV buttonRight arrowTip:Use the channel banner to determinewhether a channel is digital or analog.A digital (ATSC or QAM) channel has adash and second number after it (e.g.,21-1); an analog channel (NTSC) doesn’t(e.g., Ch 21).