RCA RCU1010 User Manual

Also see for RCU1010: Quick start guide

RCA RCU1010 User Manual Manual pdf 8 page image

8If the component you wish to control does not respond to any of the codes you have entered usingthe Code List Entry, you can search the entire Code List for a particular component that might not belisted in the Code List or might be listed under a different brand.When you enter a valid code for any given mode (e.g., when you enter a code for a TV), the defaultkey labels are displayed on the touchscreen and any previously Learned functions for that mode aredeleted. The mode is reset to its power-on default state.To search for a specific code in one of the Code Lists, follow these steps:4. Press and release the desired component key (TV, VCR,SAT, etc.) on the LCD touchscreen. For AUX, press and releasethe LCD AUX key followed by the desired component key tobe programmed under that key.Note: The AUX key automatically defaults to CABLE modeunless another selection is made.5. Enter the three-digit code for your component brand from thecorresponding Code Lists at the back of this manual. If yourbrand has more than one code listed, begin with the firstcode. When a valid code from the list is entered, the LCDdisplays the Code Save Success Screen, followed by the CodeSetup Mode? Screen. For an invalid code entry, the LCDdisplays the Invalid Entry Made Screen for two secondsbefore displaying the Code Setup Mode? Screen. In this case,no changes are made.6. Before the code can be tested on the chosen component,return to normal operation by pressing the LCD EXIT keyand then the LCD OK key on the Exit Setup Screen.7. With the component on, aim the RCU1010 at the componentand press and release the ON•OFF key. If you have enteredthe correct code number for your component, it respondsto the ON•OFF key. If the component responds, no furtherprogramming is required.8. If your component does not respond, try the next code in thelist for your brand by repeating the procedure starting at steptwo. If no other codes exist for your brand, try the CodeSearch or Code Autosearch methods.Code SearchCode List Entry (continued)1. Manually turn on the component to be controlled (TV, VCR,DVD, etc.).2. Press and hold the SETUP key on the rubber keypad for 2-3seconds until the LED indicator light remains on and thetouchscreen shows the Code Setup Mode? Screen.3. Release the SETUP key.4. Press and release the SETUP key again. The LCD displaysthe Code Search Mode? Screen.5. Press and release the desired component key (TV, VCR, SAT,etc.). For AUX, press and release the LCD AUX key followed bythe desired component key to be programmed under that key.Note: The AUX key automatically defaults to CABLE unlessanother selection is made.6. The LCD displays the Code Search Key? Screen. Press andrelease the ON•OFF key repeatedly until the component to becontrolled responds to the command and turns off. Press andrelease the LCD OK key to save the code. After you installthis code, all key labels and any previously Learnedcommands will be reset.