7Program for DBS (Satellite) orCable Box—Direct Entry MethodDBS•CABLE1. Manually turn on the DBS or CableBox system.2. Locate the enclosed DBS or CableBox Code List. Find your brand inthe DBS Cable Box Codes.Note: If your brand isn’t listed, useone of the Code Search methods toprogram this remote control. (Seesection on Code Search on page 8).3. Press and hold the CODE SEARCHkey until the indicator lightilluminates. Then release theCODE SEARCH key.4. Press and release the DBS•CABLEkey. The indicator light blinks andthen remains lit.5. Use the number keys on the remoteto enter the first code listed for yourbrand. After you enter a valid three-digit code, the indicator light turns off.Note: If you enter an invalid code, theLED flashes rapidly for two seconds.Start over at step 3.6. Aim the remote at the DBS or CableBox system. Press the POWER key.If your DBS or Cable Box system turnsoff, you have found the correct code.7. If your DBS or Cable Box system doesnot turn off, repeat steps 3-6 above,entering the next code for your brand.If none of the codes work or yourbrand is not listed, use one of theCode Search methods to program thisremote. (See Code Search section onpage 8).8. Enter the code in the box providedon this page for future reference.In order for the three-component universal remote to controlyour DBS or Cable Box system, you must program it withthe code that matches your component. Most RCA, GE andPROSCAN components do not require programming. Checkto see if your DBS or Cable Box system responds to theremote before you begin programming. To program yourremote to control your DBS or Cable Box system, followthese steps:POWER(BLINK)(OFF)08 975 642 31CODESEARCHINDICATORLIGHTDBS (SATELLITE)ORCABLE BOX CODERCU430D_US_IB_REVC 7/16/03 15:22 Page 7