MeshGuard User’s Guide4 Operating The MeshGuardMake sure the battery is installed before operating the MeshGuard. Referto page 39 for information on battery installation and replacement.4.1 Turning The MeshGuard OnHold down the [MODE] key and release it when the MeshGuard beeps.The monitor is now on, as indicated by the display:The MeshGuard performs a self-test, followed by warm-up and zerocalibration. The display briefly shows the firmware version (for example,“F1.0” means firmware version 1.0, “F2.0” means firmware version 2.0,etc.):Then the MeshGuard initializes the wireless network and displays thisinformation:Note: If MeshGuard is unable to find a radio network to connect with, itsearches, and the display alternates between “rdo” and “Srh” (for “radiosearch”).10
