MeshGuard User’s Guide356.2 Exiting Diagnostic ModeNote: You can exit Diagnostic Mode and enter Programming Mode andcalibrate the MeshGuard as usual by pressing both [MODE] and [N/-] forthree seconds.Note: You can exit Diagnostic Mode and enter Detection Mode bypressing [MODE] and [Y/+] together for three seconds, or by turning itoff and on again.6.3 Diagnostic Mode ReadingsIn Diagnostic mode, you can step through readings by pressing [N/-].6.3.1 Sensor Raw CountSensor Raw Count is indicated by “rAU” followed by a number.• Press [N/-] to advance to the next reading.• Press [MODE] and [Y/+] together for three seconds to exitDiagnostic Mode and enter Detection Mode.6.3.2 Battery Raw CountBattery Raw Count is indicated by “bAt” followed by a number.• Press [N/-] to advance to the next reading.• Press [MODE] and [Y/+] together for three seconds to exitDiagnostic Mode and enter Detection Mode.6.3.3 Temperature Raw CountTemperature Raw Count is indicated by “tNp” followed by a number.• Press [N/-] to advance to the next reading.• Press [MODE] and [Y/+] together for three seconds to exitDiagnostic Mode and enter Detection Mode.6.3.4 Sudden Power Off CountSudden Power-Off Count is indicated by “rSt” followed by a number.• Press [N/-] to advance to the next reading.