VIII User Manual Pedelec Xion 29Remember that the motor carries additional weightand the rear wheel is therefore heavier than normal!Never hold or carry the rear wheel by the cable. Thisposes the danger of the cable breaking.6. On the left axle side of the motor, there is a detachablecomponent for torque support. Place this to one side,so that it is not lost.9 Removing and installing the rearwheel9.1 Removing the rear wheel1. First, shift the bike chain to the smallest sprocket.2. Then disconnect the cable between the motor and thebattery.3. If your Pedelec is equipped with rim brakes,unhook the brake cable at the brake body (➠ GeneralUser Manual , Chapter 18.1 “Opening the brake”).4. If your Pedelec is equipped with disc brakes, refer tothe section of the User Manual concerning the technol-ogy featured in the bike for information on their han-dling (➠ General User Manual , Chapter 18.1 “Openingthe brake”).5. Release the quick-release device (➠ General User Man-ual, Chapter 9.2.2 “Operating the quick-release device”).Then remove the rear wheel from the frame by rotat-ing the rear derailleur backwards slightly, so that thechainring can be fed past it more easily.Disconnecting the cable
