Rangemaster Professional+ FX 90 Dual Fuel User's Manual & Installation Instructions

Rangemaster Professional+ FX 90 Dual Fuel User's Manual & Installation Instructions Manual pdf 14 page image

10symbol on the display will disappear and the word‘AUTO’ will flash (Fig. 2.31).7. Once the specified time has elapsed it will emit an alarm.There are two ways to cancel the alarm refer to Cancelthe Timer Alarm page 8:Reset to Manual CookingTo cancel any automatic settings turn the Timer (A) knob tothe Clock (C) setting and release (Fig. 2.32).Key LockThe Key Lock will activate and deactivate the oven.1. Cancel any active programs. Refer to Reset to ManualCooking page 10.2. Turn the Timer (A) knob to the Clock (C) setting and holdfor approx 8 seconds. The display will show ‘ON’ (Fig.2.33).3. Continue to hold the Timer (A) knob onto the Clock (C)setting, turn the Adjusting (B) knob clockwise, the ‘OF‘and the ‘Key’ symbol will display (Fig. 2.34). The oven isnow locked.4. To activate repeat steps 1 to 2 and continue to holdthe Timer (A) knob onto the Clock (C) setting, turn theAdjusting (B) knob clockwise to ‘ON’, the ‘Key’ symbolwill disappear and the oven is enabled.AccessoriesEach oven is supplied with:• Two full capacity shelves (Fig. 2.35)• Grill pan tray support (Fig. 2.36)• Two grill pans with trivets (Fig. 2.37)• Three energy saving shelves (Fig. 2.38)• Four ladder shelf supports (Fig. 2.39)• And one divider (Fig. 2.40)Oven ShelvesAny shelf can be fitted in any of the positions. The ovenshelves are retained when pulled forward but can be easilyremoved and refitted.To Remove and Refit the Ladder Shelf SupportsLift the ladder support hooks out of the two locating holes inthe oven side (or divider) before lifting the support clear ofthe bottom ladder restraint.Refit by inserting the bottom of the ladder into the restraintbefore fitting the hooks through the locating holes.To Remove and Refit the ShelvesPull the shelf forwards until the back of the shelf is stoppedby the shelf support (Fig. 2.41). Lift up the front of the shelfso the back of the shelf will pass between the supports andthen pull the shelf forward (Fig. 2.42).Refit in the reverse order, making sure to push it fully back.ArtNo.301-0007 2BCStopping the oven 1A BCArt No. 301-0011 2BCActivating the key lock 1A BCArtNo.301-0012 2BCActivating the key lock 2A BCFig. 2.32Fig. 2.33 Fig. 2.34ArtNo.326-0013 - Full capacity shelf(Falcon) ArtNo.326-0004 - Cradle shelfArtNo.331-0008 - 90SCgrill pan & trivet ArtNo.326-0015 - Energy saving shelf (Falcon)ArtNo.320-0031 90SCremoving the shelf 1ArtNo.281-0028 - Albertine dividerArtNo.320-0032 90SCremoving the shelf 2Fig. 2.35 Fig. 2.36Fig. 2.37 Fig. 2.38Fig. 2.39 Fig. 2.40Fig. 2.41 Fig. 2.42ArtNo.301-0007 2BCStopping the oven 1DA BFig. 2.31