Rangemaster Professional+ FX 90 Dual Fuel User's Manual & Installation Instructions

Rangemaster Professional+ FX 90 Dual Fuel User's Manual & Installation Instructions Manual pdf 30 page image

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSONDisconnect from electricity and gas before servicing. Check appliance is safe when you have finished.26Check in the ‘Technical Data’ section at the back of theseinstructions that the cooker is convertible to the gas youwant to use.nn This conversion must be performed by a competentperson, in accordance with these instructions andwith the local supply company requirements.nn Failure to convert the appliance correctly couldinvalidate any warranty or liability claims and leadto prosecution.nn The conversion instructions must be used inconjunction with the rest of the applianceinstruction, in particular for information onStandards, cooker positioning, connection, hosesuitability, etc.nn When servicing or replacing gas-carryingcomponents, disconnect from the gas beforestarting, and check that the appliance is gas soundafter completion.nn DO NOT use reconditioned or unauthorised gascontrols.nn Disconnect from the electricity supply beforeconversion. Before electrical reconnection, checkthat the appliance is electrically safe.InjectorsRemove the burner caps and heads. Remove the old jets.Fit the new jets: see ‘Technical Data’ section for correct jets.Reassemble in the reverse order (Fig. 8.1).Tap AdjustmentDisconnect from the electricity supply.Remove all control knobs. Open the oven door. Undo the 2screws on the oven beak (Fig. 8.2) and remove. Remove the3 fixing screws on the underside of the control. The controlpanel should drop down slightly. It is held at each end by twoholes in the top edge (Fig. 8.3) that locate on the tags on theinner panel.Lift the control panel clear of the tags and pull the controlpanel forward.Take care not to damage or strain the wiring.Bypass Screw AdjustmentTurn the bypass screw on each control clockwise to the stop(Fig. 8.4). Refit the control panel.ABCArtNo.311-0010 InjectorsA – Jet, B – Internal injector, C – External injectorArtNo.0102-0011 - Screwingthe control valve bypass screwArtNo.061-0006 - 90SC - Removing the splitterArtNo.270-0032 - 90 Prof+ FX - Removing the control panel8. Conversion to LP GasFig. 8.1Fig. 8.2Fig. 8.3Fig. 8.4