Rangemaster Professional+ FX 90 Dual Fuel User's Manual & Installation Instructions

Rangemaster Professional+ FX 90 Dual Fuel User's Manual & Installation Instructions Manual pdf 28 page image

INSTALLATIONCheck the appliance is electrically safe and gas sound when you have finished.24Electrical ConnectionThis appliance must be installed by a qualified electricianto comply with the relevant Institute of Electrical Engineers(I.E.E.) regulations, and also the local electricity supplycompany requirements.nn WARNING: THIS APPLIANCE MUST BE EARTHED.Note: The cooker must be connected to the correct electricalsupply as stated on the voltage label on the cooker, througha suitable cooker control unit incorporating a double-poleswitch, having a contact separation of at least 3 mm in all poles.The total electrical load of the appliance is approximately3.6 kW. The cable size used should be suitable for this loadand comply with all local requirements.Access to the mains terminal is gained by removing theelectrical terminal cover box on the back panel. Connectthe mains cable to the correct terminals for your electricalsupply type (Fig. 7.11 and Fig. 7.12). Check that the links arecorrectly fitted and that the terminal screws are tight. Securethe mains cable using the cable clamp.These appliances are of type X with regard to protectionagainst overheating of the surrounding surfaces.Final ChecksHotplate CheckCheck each burner in turn. There is a flame supervision device(FSD) that stops the flow of gas to the burner if the flamegoes out.To light a burner, push in and turn the associated controlknob to the high position indicated by the large flame symbol().The igniter should spark and light the gas. Keep holding theknob pressed in to let the gas through to the burner for a fewseconds.If, when you let go of the control knob, the burner goes out,then the FSD has not been bypassed. Turn the control knobto the Off position and wait for one minute before you tryagain, this time making sure to hold in the control knob forslightly longer.Oven CheckTurn on the oven and check that it starts to heat up. Checkthat the oven lights are working. Turn off the oven.Note: The oven light bulb is not included in the guarantee.ArtNo.130-0010 Electrical connections single-phaseLN230 V ac 50 Hz10 mm² max6 mm² maxCurrent Operated Earth Leakage BreakersThe combined use of your cooker and other domesticappliances may cause nuisance tripping, so we recommendthat the cooker is protected on an individual RCD (ResidualCurrent Device) or RCBO (Residual Current Breaker withOverload).IF IN DOUBT, PLEASE CONSULT A SUITABLY QUALIFIEDELECTRICIAN.L1NL3L23N ac230/400 V 50 Hz6 mm² max10 mm² max6 mm² maxFig. 7.11Fig. 7.12