Ransomes HR 9016 Turbo Dealer's Manual

Also see for HR 9016 Turbo: Parts and maintenance manual

Ransomes HR 9016 Turbo Dealer's Manual Manual pdf 11 page image

SET-UP 3GB-93 SET-UP3.1 GENERAL _________________________________________________________________The set-up and testing of the unit should always beperformed by a trained technician familiar with theoperation of this equipment.Read each instruction completely and make sure youunderstand it before proceeding with the assembly. Stayalert for potential hazards and obey all safetyprecautions.The RIGHT and LEFT, FRONT and REAR of the machineare referenced from the operator’s seat, facing forward.Accessories, such as cutting units and ROPS, notincluded with this product must be ordered separately.See instructions provided with accessory for installationand parts.3.2 INITIAL ASSEMBLY ________________________________________________________1. Check tires for proper inflation. Tires have been overinflated for transport.Tractor 10-22 psi (138-152 kPa)Deck - 20-25 psi (138-173 kPa)2. Check battery connectionsMake absolutely certain the ignition switch is “Off”and the key has been removed before servicing thebattery.Verify battery polarity before connecting ordisconnecting the battery cables.When installing the battery, always assemble theRED, positive (+) battery cable first and the ground,BLACK, negative (-) cable last.Make sure battery is properly installed and securedto the battery tray.Tighten cables securely to battery terminals andapply a light coat of silicone dielectric grease toterminals and cable ends to prevent corrosion. Keepvent caps and terminal covers in place3.3 THROTTLE STOP __________________________________________________________1. Remove throttle stop pivot hardware (B and C).2. Remove throttle stop detent hardware (D).3. Loosely assemble throttle stop pivot hardware (B).Discard washers (C).4. Move throttle stop (A) to mow position. Lock throttlestop in mow position using hardware (D).5. Securely tighten hardware (B and D). Throttle stop(A) must not be able to move.6. Start engine and push throttle lever to full throttle.Set engine speed to 2400 RPM at full throttle.Figure 3ACAUTIONDo not attempt to drive the tractor unless you arefamiliar with this type of equipment and know how tooperate all controls correctly.!WARNINGMake sure the tractor is parked on a solid and levelsurface. Never work on a tractor that is supported onlyby the jack. Always use jack stands.! CAUTIONAlways use insulated tools, wear protective glasses orgoggles and protective clothing when working withbatteries. You must read and obey all batterymanufacturer’s instructions.!AA BBBBCDDDDBefore After