Ransomes HR 9016 Turbo Dealer's Manual

Also see for HR 9016 Turbo: Parts and maintenance manual

Ransomes HR 9016 Turbo Dealer's Manual Manual pdf 13 page image

SET-UP 3GB-113.6 INITIAL INSPECTION _______________________________________________________1. Perform a visual inspection of the entire unit, look forsigns of wear, loose hardware, and components thatmay have been damaged during transport.2. Inspect paint and decals for damage or scratches.Decals provide important operating and safetyinformation. Replace all missing or hard to readdecals.3. All fluids must be at the full level mark with enginecoldCheck:a. Radiator coolant levelb. Engine oil levelc. Hydraulic fluid level4. Make sure air filter connections are tight and coveris securely in place.5. Check tires for proper inflation. Tires have been overinflated for transport. Check engine belt tension.6. Inspect battery connections and electrolyte level.Check that battery is fully charged.7. Check for fuel or oil leaks.8. Inspect lube points on tractor for proper lubrication.3.7 OPERATING CHECKS ______________________________________________________After the initial inspection test the tractor for properoperation. If tractor is being fitted an accessory you maywant to assemble these and check operation of thetractor with accessory attached.1. Test the Interlock system.[Section 3.8].2. Start tractor and check that switches, pedals andcontrols operate as described.[Section 2.2]3. Check that warning lights and alarm are working.4. Check that brake pedal does not have more thanone inch free travel before engaging.5. Operate traction pedal and check that tractoroperates smoothly in both directions. Check thattractor stops when traction pedal is released.6. Check that tractor does not drift with engine runningand traction pedal in neutral.[Section 4.7 and 4.11]7. Check adjustment of traction pedal speed limiter.[Section 3.9]8. Check that decks raise and lower correctly and thatpower take-off switch operates. Make sure bladesturn off when decks are raised. [Section 4.10]9. After operation, stop tractor and inspect again for oilor hydraulic leaks.10. Check and if necessary adjust cutting height andlevel decks. [Sections 4.2, 4.4 and 4.5]CAUTIONThe initial inspection should be performed only when the engine is off and all fluids are cold. Lower decks to theground, engage parking brake, stop engine and remove ignition key.!