Operation manual - Spider ILD0124 / 54 rev. 07-01-01-20109. PREPARING THE MACHINE9.1 MACHINE DELIVERY TO A DEALEROR RETAILERFrom the manufacturer the machine isdelivered filled with engine oil andhydraulic oil but without gasoline in the tank.The training of the operator should take place duringthe installation of the product.The mower may be delivered on a wooden pallet or ina crate.To take the mower off the pallet• Place the palette with the mower on a levelsurface• Carefully remove the upper boards of thecrate and take out all accessories & theremote control Disassemble the side boardsof the crate• Release the attachment fastening themower to the pallet, remove transportationwrapping. Recycle these wraps.• Thoroughly examine the mower for possibledamage and missing parts from thedelivery. If necessary, contact thetransporting company with your claim.• Before driving down from the pallet raise themowing mechanism to the upper position(this can be done without starting theengine)• Place boards in front of the wheels in thedirection, in which you expect to drive themower from the pallet to the ground. Put atleast 5 litres of fuel to the tank and attachcables onto the battery. While starting,follow instructions in chapter 5.• The aerial must be attached to the mower• After starting the engine set the speedcontroller on the transmitter to the (L)symbol – lower driving speed• Slowly move the forward/reverse joystick tocorrespond with the direction you want tomove the mower. The arrow on the wheellegs indicates forward.• Slowly drive down to the ground and stopthe engine• While unpacking, assembling and preparingthe mower, do not engage the mower blade.Součásti dodávky:• SPIDER mower• Mower ignition key (X2)• Gel battery (12v starting)• Remote control including 2 batteries• Remote control battery charger (12v – 12v)• Operation manual• Radio controller key (X2)• Engine user’s and maintenance manual• RC instruction manual• Copy of the EC declaration of conformity• Copy of the EC declaration of konformity forRemote controller NBBIf you have a lifting device with asufficient lifting capacityavailable, place the liftinghooks/eyes on spots marked with the symbolsof chain, lift the load by about 0,15 m (6inch),move the pallet away from the mower andlower the machine to the ground.There may not be enough fuel inthe fuel system when starting forthe first time and you may needto repeat the starting several times. Startingperiod must not exceed 3 seconds. Theremust be a pause of at lest 20 secondsbetween all attempts to start the engine.