Operation manual - Spider ILD0128 / 54 rev. 07-01-01-20109.9 PREPARING THE HETRONIC REMOTE RADIO CONTROLLERInsert the battery (type 3,6V NiMh, 1200mAh) into the remote radio controller.If LED flashes green, the battery is charged.If the remote radio controller battery voltage is below the required level, the entire machine will turn offautomatically.Discharge signal – if the voltage of the remote radio controller battery is too low, the colour of the LED on theremote radio controller changes (LED flashes yellow). Move the mower to a safe place and replace thebattery. After the low voltage is indicated, you have about 10 minutes to move the mower to a safe place. After10 minutes the remote radio controller will be turned off permanently. If the battery is exhausted, replace it witha reserve battery.The tr ansmitter (r emote r adio controller) a nd th e r eceiver (c ontrol u nit) w ere a djusted a ndset-up b y th e manufacturer. D o n ot m ake a ny m odifications to th ese d evices. T hey a re amatched pair.9.10 CHARGING THEHETRONIC REMOTE RADIO CONTROLLER BATTERYTo charge the battery:Connect the charger to the electric power outlet in your car.Insert the battery into the charger (LED CHARGE flasher for 2 seconds and then shines during charging).Leave the battery in the charger as long as necessary (the charger controls the charge level and does notovercharge the battery).Fast charge – after connecting the battery press the FAST CHARGE button.When the battery is fully charged, the green LED READY shines.10 OPERATION10.1 TRANSPORTING THE MOWERThe mower should be transported to the mowing area on a trailer orother suitable transport vehicle.Transporting the mower on thoroughfares on its own wheels isprohibitedWhen loading/unloading a trailer, make sure that the edge - formed bythe floor of the trailer and the ramps – is not an obstacle for the mower.Otherwise you need to use longer ramps.When loading, do not allow any person to stand by the ramps or underthe hanging mower if it is lifted. It may only be hung upon places marked by the chain symbol. The loading capacity of thelifting eyes/ hooks must be suitable for the weight ofthe machine as quoted on the serial plate.After placing the mower on the transport, make sure it is properlysecured. Attach fastening devices to the eyes marked by the chainsymbol on the mower.