Raritan Paragon II P2-UMT1664M User Manual

Also see for Paragon II P2-UMT1664M: User manual Quick guide Quick setup guide User guide Quick installation and setup guide

Contents

CHAPTER 5: PARAGON II AND Z-CIM 45Chapter 5: Paragon II and Z-CIMIf you have a local PC CPU that you want only the user(s) at a certain user station to be able to access, butyou want that user station to be able to access the CPUs attached to the Paragon system as well, insert aP2CIM-PS2 dual-access CIM between a User Station and a Base Unit.To do this for a given user station:1. If you have not already done so, install your Paragon system as described in Chapter 2: Installation.2. Take the cable that connects the user station’s User Station to the Base Unit and disconnect it from theBase Unit’s user port.3. Connect the free end of this cable to the RJ-45 port labeled “UTP OUT” on the ZCIM-PS2.4. Run another CAT5 cable from the RJ-45 port labeled “UTP IN” on the ZCIM-PS2 to the same userport on the Base Unit from which you disconnected the other cable.5. Plug the ZCIM-PS2’s HD15 strand into the HD15 VGA video port of the CPU you want the userstation to have local access to. Plug its purple 6-pin mini-DIN keyboard strand into the CPU’s 6-pinmini-DIN keyboard port. Plug its light green 6-pin mini-DIN strand into the CPU’s 6-pin mini-DINmouse port.6. Plug in and power ON the CPU. If the P2CIM-PS2 is installed and operating properly, the P2CIM-PS2’s green LED will start blinking: once per second while the P2CIM-PS2 is idle, or more quicklywhile data passes in either direction.Once this installation is finished, activate Local PC Mode on the User Station:1. Log on at the attached user station.2. Press the hotkey ([Scroll Lock] is the default) twice in quick succession to activate the OSUI.3. Press [F4] to activate the User Profile Menu (see Chapter 3: Operation – User Functions, UserCustomization).4. Use [Tab] or the up- and down-arrow keys to move the highlight to the Local PC field.5. Press the [Enter] key. The Local PC field will turn green.6. Use the up- or down-arrow key to toggle the value of the field to “On.”7. Press the [Enter] key. The highlight will turn yellow.8. Press [S] to save the change and return to the User Profile Menu. If you do not wish to save changes,press the [Esc] key to abort the change and return to the User Profile Menu.Once Local PC Mode is turned on, you can access the dedicated local PC CPU from this user station bypressing the [Home] key twice in quick succession while the OSUI is on-screen. The User Station willimmediately switch you to the local PC. To return to the Paragon system and its switched CPUs, activatethe OSUI by pressing the hotkey twice ([Scroll Lock] is the factory default), then press [F2] to activate theSelection Menu and access any of the listed servers.