6 PARAGON II USER G UIDE3. Connect one end of a Category 5e UTP cable to User Port #1 on the back of the MainSwitching Unit. Connect the other end of the cable to the “Cat5 Port” on the back of the UserStation (P2-UST or P2-EUST).4. Connect a power cord to the User Station. Power ON the User Station.5. Connect a PS/2 keyboard, mouse, and VGA monitor to the User Station. Power ON themonitor.6. Connect one end of a Category 5e UTP cable to Channel Port #1 on the back of the MainSwitching Unit (or Stacking Unit, if attached). Connect the other end of the cable to the RJ45port on a Computer Interface Module (P2-CIM).7. Connect the P2-CIM to server’s keyboard, video, and mouse ports.8. Power ON server.9. Repeat steps 3 through 8 for all other CPUs you want to attach.Note: Although users and servers can be located up to 1000 (304 m) apart, for optimal videoquality, limit cable length between the Main Switching Unit and CIM to less than 100 feet (30.5m). For good video quality, limit cable length between the Main Switching Unit and CIM to lessthan 500 feet (152 m).Initial Administrative TestingTo verify that an attached server can be viewed and controlled through the Paragon system:1. When you first power ON the Paragon Base Unit, an attached User Station, and the UserStation’s attached monitor; the Login screen appears. Type admin in the User Name fieldand press ENTER. Type raritan (all lowercase) in the Password field and press ENTER.Note: The factory-default user names are user01 through up to user16 (depending on the modelof the Base Unit) for regular users and admin for the admin user. User names are not case-sensitive. By default, a password is required only for the admin user, and that password is raritan.Passwords are case-sensitive.Figure 5 Login Menu
