CHAPTER 2: I NSTALLATION 15C. The OSUI’s Selection Menu appears, indicating that the User Station is correctlyinstalled.Figure 20 Selection Menu4. Repeat steps 2 and 3 for each User Station you want to connect to the Base Unit.5. Connect a P2CIM-PS2 and its server CPU.A. Connect the cable strands of an appropriate P2CIM-PS2 to the desired ports on a serverCPU:1. P2CIM-PS2 (IBM PS/2 compatible CPUs): Plug the HD15 strand into the CPU’sHD15 VGA video port. Plug the purple 6-pin mini-DIN keyboard strand into theCPU’s 6-pin mini-DIN keyboard port. Plug the light green 6-pin mini-DIN strandinto the CPU’s 6-pin mini-DIN mouse port.2. P2CIM-SUN (Sun compatible CPUs): Plug the HD15 strand into the CPU’s HD15VGA video port. Plug the 8-pin mini-DIN strand into the CPU’s 8-pin mini-DINkeyboard/mouse port.3. P2CIM-USB (USB CPUs of any platform, P2 CIM-SUSB, or P2CIM-USBG2): Plugthe HD15 strand into the CPU’s HD15 VGA video port. Plug the USB Type A strandinto one of the CPU’s USB Type A ports. The P2CIM-USBG2 comes with a toggleswitch that allows users to switch between PC/MAC USB configurations and SUNUSB configurations.4. P2CIM-PS2DUAL (IBM PS/2 compatible CPUs): Connect keyboard, monitor, andmouse cables attached to the P2CIM-PS2DUAL to the appropriate 15-pin femalevideo port and 6-pin mini-DIN mouse and keyboard ports on the computer.5. AUATC (serial CPUs, routers, etc.): Please see Appendix E: Using AUATC forRS-232 Access for installation instructions.6. Z-CIM (local single-user IBM PS/2 compatible CPUs): Please see Chapter 5:Paragon II and Z-CIMs for installation instructions.B. Plug in and power ON the CPU. If the P2CIM-PS2 is installed and operating properly,the P2CIM-PS2’s green LED will start blinking: once per second while the P2CIM-PS2is idle, more quickly while data is passed in either direction.C. Connect one end of a CAT5 UTP cable to RJ45 port #1 on the back of the Base Unit.Connect the other end of cable to the RJ45 port on the P2CIM-PS2.6. Configure the P2CIM-PS2 and the attached CPU.A. The monitor attached to the User Station will display the Selection Menu; with the CPUyou just connected displayed in green. Use the Ç and È keys to move the highlight tothat entry and press ENTER. If you can access and operate the CPU normally, theP2CIM-PS2 is connected successfully. Raritan recommends you give the server ameaningful system name at this time, as described in the next steps.
