Raven SCS 460 Installation And Service Manual

Also see for SCS 450: Installation manual Installation & service manual

38APPENDIX 3ALTERNATE BY-PASS LINE PLUMBING SYSTEMFIGURE 11INITIAL SYSTEM SET-UPPlumb the system as shown in Figure 11. Adjust as follows:Install Polarity Reversal Jumper in motorized Control Valve Cable (P/N 115-0159-415).1) Fill tank with water only.2) Place MASTER ON/OFF switch to ON and BOOM ON/OFF switches to OFF.3) Place AUTO/MAN/OFF switch to MAN, and POWER ON/OFF to ON.4) Verify that Boom Widths, SPEED CAL, METER CAL, VALVE CAL and RATE CALS have beenentered correctly into the Console. In SELF TEST mode enter the normal sprayer operating speed.Under DATE MENU, verify tier control is in manual mode (TIER MAN) and all 3 tiers are on.5) With pump not running, fully open main line hand valve, fully open by-pass #1 hand valve, andcompletely close agitator line hand valve. If positive displacement pump is used, fully openpressure relief valve, PRV.6) Run pump at normal operating RPM.7) If centrifugal pump is used, proceed with Step 8. If positive displacement pump is used, proceedas follows:a) Place MASTER ON/OFF switch to OFF.b) Close by-pass #1 hand valve.c) Set PRV to 65 psi [450 kPa].d) Open by-pass #1 hand valve.e) Place MASTER ON/OFF switch to ON.