52. MOUNTING THE FLOW METER1) Mount Flow Meter in the area of the boom valves per Figure 4. All flow throughFlow Meter must go to booms only, i.e., no return line to tank or pump after FlowMeter.2) Mount Flow Meter horizontal to the ground. Use the bracket to secure the FlowMeter.3) For best results, allow a minimum of 7 1/2 inches [20 cm] of straight hose on inletof Flow Meter. Bend radius of hose on outlet of Flow Meter should be gradual.4) Flow must be in direction of arrow on Flow Meter.FIGURE 4FIGURE 4FIGURE 4FIGURE 4FIGURE 43. MOUNTING THE CONTROL VALVE1) Mount the motorized Control Valve in the main hose line between the Flow Meterand the booms, with motor in the upright position. (For flow less than 3 GPM[11 lit/min] the motorized Control Valve is mounted in a by-pass line. Refer toAppendix 3 for alternate plumbing diagram).2) Connect the Flow Control Cable connectors to boom valves, Flow Meter, and motorizedControl Valve. (Black wire to boom valve #1, Brown to boom valve #2, Blue to boomvalve #3, Blk/wht to boom valve #4, Brn/wht to boom valve #5, Blu/wht to boom valve#6, Wht/blk to boom valve #7).NOTE: It is essential, when using suspensions, that the system be thoroughlyrinsed out each day after use.