Description1 Pilot Status — Current pilot mode.2 Current Heading.3 No (Standby) — Disengages the autopilot and returnsto manual vessel control.4 Rudder bar — Indicates the position of the rudder.5 Turn angle — The turn angle is only available forSeaTalkng autopilots. This indicates the direction andseverity of turn.6 Yes (Track) — Engages the autopilot in Track modeand automatically steers your vessel to a targetwaypoint or along a route plotted on your MFD.7 Distance to next waypoint (DTW) and Bearing to nextwaypoint (BTW).8 Next Waypoint name.9 Close — Closes the Pilot Control dialog.Pilot Control dialog (Track)The example below shows the Pilot Control dialogoptions when in track mode.Displaying the Pilot Control dialogThe Pilot Control dialog is displayed under thefollowing conditions:1. When the physical Pilot button is pressed.2. When Pilot Controls selected from the shortcutspage.3. When you select Menu > Navigate > GotoWaypoint , Goto Cursor or Follow Route optionin the Chart application.4. When you select Goto Waypoint or Goto Cursorusing the Chart context menu.5. When you place the cursor over an active routeor waypoint in the Chart application and selectStop Goto, Stop Follow or Advance Waypointfrom the context menu.6. When you are following a route or going to awaypoint or cursor position, and select Menu> Navigate > Stop Goto, Stop Follow, orAdvance Waypoint.7. When you arrive at a target waypoint.Note: When arriving at a waypoint, the dialog titlebar turns red to indicate waypoint arrival.11.8 Pilot BarThe Pilot Bar provides autopilot status information.For touchscreen displays you can disengage theautopilot using the Pilot Bar.Pilot Bar — Track modePilot Bar — Auto modeThe Pilot Bar is displayed when autopilot controlis enabled, the Pilot Bar is switched on and theautopilot is engaged.When the autopilot is disengaged the Pilot Bar ishidden.On a system containing multiple displays the PilotBar can be disabled or enabled on each display.Enabling the Pilot BarWhen connected to a SeaTalk or SeaTalkng SPXautopilot the Pilot Bar can be enabled by followingthe steps below.From the Homescreen, with autopilots controlsenabled:1. Select Customize.2. Select Display Preferences.3. Select Pilot Control Bar so that Shown ishighlighted.Selecting Pilot Control Bar will switch the PilotBar between Shown and Hidden.4. Engage the autopilot.The Pilot Bar is now displayed at the bottom ofthe screen in all applications whilst the autopilot isengaged.Note: When connected to an Evolution autopilotthe Pilot Bar is enabled from the Pilot Set-up page.166 a Series / c Series / e Series
