3. Select the fullscreen feed.The Quad View icon is displayed.4. Select the Quad View icon to switch the Cameraapplication back to Quad View.22.4 Camera cyclingWhen multiple feeds are available the Cameraapplication can be set up to automatically cyclethrough the available feeds at a specified timeinterval.Note: Camera cycling is not available whenthe Camera application is viewed as part of asplitscreen page.With camera cycling turned on the Cameraapplication will cycle through the display’s availablevideo input(s) and any available networked IPcamera feeds. The feeds will be cycled in the orderthey appear in the Camera selection menu: Menu> Camera View > Camera:. Direct video inputfeeds will appear first followed by any networked IPcamera feeds. When the final feed in the list hasbeen displayed the Camera application will loopback to the first feed in the list.Camera cycling will cycle through the multifunctiondisplay’s available video input(s) even if no feed isconnected to the input(s). When no feed is presenton a video input the ‘No video source available’message is displayed. You can choose whether ornot the video input(s) appear during camera cycling.The time interval that each feed is displayed, beforeswitching to the next feed can be adjusted.Enabling camera cyclingCamera cycling can be enabled independently inboth Single View and Quad View.From the camera application:1. Select Menu.2. Select Camera View.3. Select Camera Cycling.4. Select Camera Cycling: so that On ishighlighted.Selecting Camera Cycling will switch cycling Onand Off.When the menu is closed the camera application willcycle through all available feeds at the defined timeinterval.Setting the time interval for camera cyclingThe time interval that each video feed is displayedfor can be adjusted. The time interval specified willapply to Camera cycling in Single View and QuadView.From the Camera application, with Camera cyclingturned on:1. Select Menu.2. Select Camera View.3. Select Camera Cycling.4. Select Cycle Interval:.The cycle interval adjustment control is displayed.5. Adjust the setting to the required time interval.During camera cycling each feed is displayed for thespecified time before changing to the next feed.344 a Series / c Series / e Series
