Red Epic REDCAST Operation Manual
                                   | |
Contents
| 
CoPYRIGHT © 2015 RED.CoM, INCR E D C A S T M o D u l E o P E R AT I o N G u I D E955-0072, REV-H | 2TABLE OF CONTENTSDisclaimer 3Copyright Notice 3Trademark Disclaimer 3Compliance Statements 3Safety Instructions 5Chapter 1: REDCAST Module Introduction 6Introduction 6System Requirements 7Additional Resources 7Chapter 2: REDCAST Module Connectors 8REDCAST Module Connectors 8SDI-OUT Pinout 9SYNC Pinout 9TC Pinout 9Chapter 3: Install and Connect the Module 10Install the REDCAST Module 10Remove the REDCAST Module 11Output Quad UHD or 1080p 12Set Up Timecode with the REDCAST Module 16Set Up Genlock with the REDCAST Module 17Enable a Test Pattern 20REDCAST Module Status 21Chapter 4: Load and Use 3D LUTs 22Compatible 3D LUT Formats 22Manage 3D LUTs 22Output 3D LUTs via the REDCAST Module 243D LUT Algorithms 25Chapter 5: REDCAST Module Maintenance 26Clean REDCAST Module Exterior Surfaces 26Store REDCAST Module 26Water Damage 26Chapter 6: Troubleshoot Your REDCAST Module 27Err (Error) Link Status 27Video Does Not Display Correctly 27No Timecode in Via REDCAST Module 27Cannot Genlock Via REDCAST Module 28Genlock Not In Sync When Using Long Cables 28Can Only Select Quadrant as Output 28Appendix A: Technical Specifications 29Appendix B: REDCAST Module Compatibility 30Supported Frequencies 30Attach REDCAST Module 30Compatible RED Devices 30Compatible Timecode and Genlock Devices 30Compatible Third-Party Devices 31Appendix C: REDCAST Module Workflow 32Essential (Basic) Broadcast Setup 32Broadcast Setup with SMPTE Fiber Bridge 33 |
Related manuals for Red Epic REDCAST
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine