RedLeaf 32 Series User Manual
                                                                                                                                              | |
Contents
| 
53Figure 4-584.6.7 DetectGo to Detect MenuIn the main menu, from Setting to Detect, you can see motion detect interface. See Figure 4-59.There is three detectiontypes: motion detection, video loss, camera masking.Motion DetectDetection menu is shown as below. See Figure 4-59 Event type: from the dropdown list you can select motion detection type. Channel: select the channel to activate recording function once alarm occurred. Please make sure you have set MD recordin encode interface(Main Menu->Setting->Schedule) and schedule record in manual record interface(MainMenu->Advanced->Manual Record) Latch: when motion detection complete, system auto delays detecting for a specified time. The value ranges from10-300(Unit: second) Region: Click select button, the interface is shown as in Figure 4-60. Here you can set motion detection zone. There are396(PAL)/330(NTSC) small zones. The green zone is current cursor position. Grey zone is the moti on detection zone.Black zone is the disarmed zone. You can click Fn button to switch between the arm mode and disarm mode. In armmode, you can click the direction buttons to move the green rectangle to set the motion detection zone. After youcompleted the setup, please click ENTER button to exit current setup. Do remember click save button to save current setup.If you click ESC button to exit the region setup interface system will not save your zone setup. Sensitivity: System supports 6 levels. The sixth level has the highest sensitivity. Show message: System can pop up a message to alarm you in the local host screen if you enabled this function. Alarm upload: System can upload the alarm signal to the network (including alarm centre) if you enabled curr entfunction. Send email: System can send out email to alert you when alarm occurs. PTZ activation: Here you can set PTZ movement when alarm occurs. Such as go to preset, tour &pattern when there is analarm. Click “select” button, you can see an interface is shown as in X305H305H305HFigure 4-61X. Period: Click set button, you can see an interface is shown as in Figure 4-62. Here you can set for business day andnon-business day. In Figure 4-62 click set button, you can see an interface is shown as in Figure 4-63. Here you can setyour own setup for business day and non-business day. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine