Regency CV72EPV-NG Owners & Installation Manual

Also see for City CB72EPV-LP: Important information Owners & installation manual

Contents

City Series CV72EPV | 11owner's informationProflame II Remote control operating instructions919-829 09.29.17PROFLAME II REMOTE CONTROL OPERATING INSTRUCTIONSWARNING:THE TRANSMITTER AND RECEIVER ARE RADIOFREQUENCY DEVICES. PLACING THE RECEIVER IN ORNEAR METAL MAY SEVERELY REDUCETHE SIGNAL RANGE.The Proflame 2 Transmitter provides for controlling the following hearthappliance functions:1. Main Burner On/Off2. Main Burner flame modulation (6 levels)3. Choice of standing or intermittent pilot (CPI/IPI)4. Thermostat and Smart thermostat functions5. Accent light modulation (6 levels)**6. Split flow valve**7. Comfort Fan speed modulation (6 levels)**** This feature is not available on all models.IMPORTANT:The Proflame Transmitter 2 is an integrated part of theProflame 2 System, which consists of these elements:• Proflame 2 Transmitter, to be used in conjunction with:• Integrated Fireplaces Control (Proflame 2 IFC)The Proflame Transmitter uses a streamline design with a simple buttonlayout and informative LCD display (Fig. 1). A Mode Key is provided toindex between the features and a Thermostat Key is used to turn on/offor index through Thermostat functions (Fig. 1 & 2). Additionally, a KeyLock feature is provided (Fig. 22).Figure 1: Proflame TransmitterFigure 2: Transmitter LCD DisplayTECHNICAL DATAREMOTE CONTROLSupply Voltage 4.5V (three 1.5V AAA batteries)Ambient temperatureratings0 - 50 oC (32 - 122oF)Radio Frequency 315 MHZATTENTION!- Turn “OFF” the main gas supply of the appliance during installation ormaintenance of the Receiver device.- Turn “OFF” main gas supply to the appliance prior to removing or rein-serting the batteries.- In case of remote control malfunction, turn off the IFC device using the"ON/OFF" main switch.- For installation / maintenance, switch off the IFC device removing mainpower supply plug.OPERATING PROCEDUREInitializing the System for the first timePower the receiver. Activate the procedure of the receiver address pro-gramming, see the receiver instruction (*). The Receiver will “beep” three(3) times to indicate that it is ready to synchronize with a Transmitter. Installthe 3 AAA type batteries in the Transmitter battery bay, located on thebase of the Transmitter. (fig. 3) With the batteries already installed in theTransmitter, push the On button. The Receiver will “beep” four times toindicate the Transmitter’s command is accepted and sets to the particularcode of that Transmitter. The system is now initialized.(*) The receiver may be independent or integral to the IFC hearth ap-pliance control module. The receiver instruction may not be indepen-dent when part of the IFC.Figure 3: Battery CompartmentPROFLAME 2TRANSMITTERUSEANDINSTALLFig3: Batterycompartment.1* Actual transmitteris black.