94 | City Series CB72EPVinstallationOptional Birch Wood Log Set Installation919-904 08.14.18Read the instructions below carefully and refer to the images. If the logs are broken do not use the unit until they are replaced.Broken logs can interfere with pilot operation.Improper positioning of the logs may create carbon build-up and can alter the unit's performance which is not covered under warranty.*Paint is included if touch ups are required.1 Rear Center Log2 Rear Left Log3 Rear Right Log4 Left Front Log5 Front Log (left of center)6 Front Centre Log Piece7 Front Right Log (right of center)8 Front Right Log9 Left cross log (2nd left from center)10 Left cross log (left of center)11 Right cross log (right of center)12 Right cross log (2nd right from center)13 Left cross log (far left log)14 Right cross log (far right log)15 Left end log16 Right end logLog Brackets (3)Lava rock (purchased separately from log set)2 lb Black Fireglass (purchased separately from log set)Glowing wool (supplied with unit)3/4" Crushed black glass or iceburg chips(purchased separately from log set)1. S hut off gas and electrical supply, allow unit to cool to room temperature.2. Remove barrier glass (if already installed) and fi rebox glass (see manual).3. Carefully remove the logs from the packaging and unwrap them.The logs are fragile, handle with care—never force into position.4. Install Black Fireglass (2lb) and glowing wool on the burner as shown below.Burner covered with Fireglass andglowing wool5. Clip on the log guides - position the rear guides by centering over thetwo vertical lines on either side of the pilot hood at the back of the burner.Install a second log guide on the 2nd vertical line right of the pilot hood.Left log guide Right log guides12 31013495 6 7 81114161512Log guides installed1CITY SERIES 72CITY SERIES 72 - LOG INSTALLATION
