Regency City Series Owners & Installation Manual

Also see for CB40E-LP11: Manual

60 | CV40E-11 City SeriesinstallationCV40E Enamel Panel Installation919-653 06.08.16CV40E ENAMEL PANEL INSTALLATIONBlack Enamel Panels — Handling Instructions• Black Enamel panels must be inspected for scratches and dimples prior to installation.All claims to be recorded at this time.Claims for damage after installation will not receive consideration.• Black Enamel panels will discolor a little during normal operation. This is normal and should not be considered a defect.* All hand and finger marks MUST be cleaned off with a soft cloth. Use an ammonia based cleaner (ie. glass cleaner) to remove any fingerprints beforeapplying heat to the unit.Failure to do this will result in burn stain on panels which you will be unable to remove.*Not protected by product warranty.1. Turn off unit and allow to cool to room temperature. Remove the safety glassand firebox glass — see manual for instructions.2. Install enamel inner firebox base panel as shown.1. Turn off unit and allow to cool to room temperature. Remove the outer safetyglass — see manual for instructions.2. Attach Regency logo to the right hand side of outer front panel. The magnetswill be positioned under the outer front base panel to secure the logo. Installouter front base panel.CV40 inner panel installationCV40 outer panel installationInstall bracket intoslot in panelBack Panel3. Install side panel - the side panel is secured in place by existing magnetsin the unit.4. Reinstall outer safety glass.3. Install back enamel panel - manoeuvre panel into unit and positionpanel at back wall of firebox.NOTE: Side panels when secured, will hold back panel in position.4. With back panel in position — install side panel.Place panel bracket into slot located at top of panel. Place panel andbracket in unit against the side wall. Slide keyhole bracket (installedin panel) over screw in unit to secure side panel.5. Repeat on opposite side.Location ofRegency Logo1CITY SERIES