Regency City Series Owners & Installation Manual

Also see for CB40E-LP11: Manual

68 | CV40E-11 City SeriesinstallationOptional Splitwood Log Set Installation920-086 08.26.19Read the instructions below carefully and refer to the images. If the logs are broken do not use the unit until they are replaced. Brokenlogs can interfere with pilot operation.Improper positioning of the logs may create carbon build-up and can alter the unit's performance which is not covered under warranty.*Dark brown paint is included if touch ups are required.1 Rear Log2 Left Log3 Right Log4 Left Cross Log5 Right Cross Log6 Front Left Log Piece7 Front Middle Log Piece8 Front Right Log PieceLog Brackets (2)Lava rock (purchased separately from log set)1.5 lb Black Fireglass (purchased separately from log set)Glowing wool (supplied with unit)3/4" Crushed black glass or iceburg chips(purchased separately from log set)1. Shut off gas and electrical supply, allow unit to cool to room temperature.2. Remove safety glass and fi rebox glass (see manual).3. Carefully remove the logs from the packaging and unwrap them.The logs are fragile, handle with care—never force into position.4. Install Black Fireglass (1.5lb) and glowing wool on the burner asshown below.5. Clip on the log brackets - position the rear guides by centering over thesecond and fourth vertical lines at the back of the burner.Log 1 in positionLog bracketsBurner covered with Fireglass and glowing wool6. Place Log 1 on the top of the installed rear log guides. Center it on theburner, as shown below.Log 1 in position1CITY LINEOPTIONAL SPLITWOOD LOG SET INSTALLATION