10 Regency ® E21-2 Gas Fireplace InsertWIRING DIAGRAMSINSTALLATIONCAUTION: Label all wires priorto disconnection when servicingcontrols. Wiring errors cancause improper and dangerousoperation.WARNING: Electrical GroundingInstructionsThis appliance is equipped with athree pronged (grounding) plug foryour protection against shock hazardand should be plugged directly intoa properly grounded three-prongreceptacle. Do not cut or remove thegrounding prong from this plug.This heater does not require a 120V A.C. supplyfor operation. In case of a power failure, theburner switch and the optional remote control/thermostat will continue to operate. However,a 120V A.C. power supply is needed for thefan/blower operation.Caution: Ensure that the wires donot touch any hot surfaces and areaway from sharp edges.When connected with 120 volts, the appliancemust be electrically grounded in accordancewith local codes or, in the absence of localcodes the current CSA C22.1 (in Canada) orwith the National Electrical Code ANSI/NFPA70-1987 (in USA).NOTE: This unit is equipped with a heatsensor thermodisc which willprevent the blower from operatinguntil the unit reaches the correcttemperature.GreenGroundNeutralLiveBlackBlackRed BlackFanThermodiscON OFFRotary SpeedControl120V AC60 HzGround FanGroundingLug DetailLockwasher Fan groundPower cordground wireStar washerNutNut#8 Ground LugStar washerGas PilotThermopileElectrodeGasInPiezoIgnitorThermocouple InBrownRedWhitePilotAssembly"S.I.T" ValveHILOOFFONPILOTVent SpillSwitch(Auto Reset)BurnerONOFFRemote Transmitter(Optional)Thermostat(Millivolt)(Optional)RemoteReceiver(Optional)(Millivolt)ONOFFRegencyBlackRedFor NATURAL GAS Units and Units NOT Equipped with DC Spark Boxes