Regency E21-LP2 Owners & Installation Manual

16 Regency ® E21-2 Gas Fireplace InsertBAY LOUVERS1) Install top louver by sliding the two bracketclips into the brackets located on top of thebay door. See below. The fitted louver leavesa small gap between faceplate bottom andlouver top.Diagram 1NOTE: The top and bottom trim piecesare different.OPTIONAL BAY FRONTIMPORTANTFlush glass must stay in placewhen bay option is used. The bayfront is a decorative overlay only.1) Place the bay door onto the 2 pins on thetop of the unit.2) Position 2 magnets on the back of each trimpiece close to the ends. Place the top andbottom trim pieces on the bay front.3) Install top and bottom louvers.Note: Top and bottom louvers and bracketsare different. See diagram below.2) Install bottom louver by sliding the twobracket clips into the brackets locatedunderneath the bay door and secure with2 screws into the bracket on the bottom ofthe Bay Front as per diagram 1.FLUSH LOUVERS1) The Top Louver is held in place by SpringClips. Push into place as shown.2) Install the Spring Hinges on the left and rightside of the bottom of the Firebox using 2screws per hinge.3) Place the Bottom Louver near the hinge. Fliphinge over the Bottom Louver and secureusing 3 screws.Bottom LouverHingeLocationINSTALLATION