Regency E21-LP2 Owners & Installation Manual

14 Regency ® E21-2 Gas Fireplace InsertThe front bottom of Log D)02-70 sits snuglybetween Logs C) 02-68 and Log B)02-67.7) Place the embers on the front lip of theburner as shown below.8) Place pieces of rockwool on the front lip ofthe burner as shown below.4) Place the Front Left Log B) 02-67 on the 2front pins.FACEPLATE & TRIMINSTALLATION1) Lay the faceplate panels flat, face down onsomething soft so they don't scratch.2) Take the top faceplate and align the holesin it with the holes in the side panels. Usingthe screws provided, attach from the top ofthe panel (the holes in the top panel areslightly larger than the holes in the sidepanel to facilitate easier installation). Seediagram 1. Hint: Don't tighten the trim tothe bottom of the faceplate side panels withthe screws provided. See diagram 1.E)02-69Cutoutfits overthe rightedge ofthe burnertray.6) Position the Middle Left Log C) 02-68 ontothe 2 pins as shown below. The left edgeof the log fits into a notch on the Front LeftLog B) 02-679) Place the Front Right Log E) 02-69 onto thefront right pin and the cutout on the bottomright side of the log snugly against the rightedge of the burner tray.Vermiculite& EmbersVermiculite &EmbersVermiculite& EmbersLOG SETINSTALLATIONRead the instructions below carefully andrefer to the diagrams. If logs are brokendo not use the unit until they are replaced.Broken logs can interfere with the pilotoperation.The gas log kit (set# 532-930) containsthe following:a) 02-66 Rear Logb) 02-67 Front Left Logc) 02-68 Middle Left Logd) 02-70 Middle Right Loge) 02-69 Front Right Logf) Embersg) Vermiculiteh) RockwoolNote: Install Optional Brick Panels prior toinstalling logs.1) Carefully remove the logs from the box andunwrap them. The logs are fragile, handlewith care - do not force into position.The "02" refer numbers (i.e. 02-66) aremolded into the rear of each log.2) Sprinkle the vermiculite around the fireboxbase. Take some of the embers (approx. 1/3of the bag) and sprinkle over the vermiculite.3) Place theRear LogA ) 0 2 - 6 6on the 2pins on ther e a r l o gsupport andc a r e f u l l yp u s hdown.A)02-66B)02-67C)02-68D)02-70E)02-695) Place the Middle Right Log D) 02-70 into thecutout on Rear Log A) 02-66 and the bottomfront of Log D)02-70 snugly between LogsC) 02-68 and Log B)02-67.NOTE: Keep the gasket on the front edgeof the firebox clear of vermiculite.INSTALLATION