Regency P121-NG2 Owners & Installation Manual

Also see for P121-LP2: Specifications

Contents

10 Regency ® P121-2/P121LC-2/P121RC-2/P131-2 Zero Clearance Direct Vent Gas FireplaceINSTALLATIONINSTALLATIONCHECKLISTNote: These units arenon-load bearing.1) Locate appliance. Refer to the followingsections:a) Locating Your Fireplaceb) Clearancesc) Combustible Mantel Clearancesd) Framing & Finishinge) Venting. See the "Venting Introduction"to "Venting Arrangements" sections.2) Assemble Top Standoffs. Refer to the "UnitAssembly Prior to Installation" section.(NOTE: must be done before installingunit into fireplace.)3) Install vent. See the "HorizontalInstallations" to "Installation Procedures"sections4) Make gas connections. Test the pilot. Mustbe as per diagram. Refer to the "Gas LineInstallation" & "Pilot Adjustment" sections.5) Install standard and optional features. Referto the following sections where applicable:a. Log Setb. Glass Doorc. Finishing Trimd. Louvers & Grillse. Remote Controlf. Wall Switchg. Wall Thermostat6) Final check.Before leaving this unit with the customer,the installer must ensure that the appliance isfiring correctly and operation fully explained tocustomer.This includes:1) Clocking the appliance to ensure the correctfiring rate (rate noted on label 40,000 Btu/hNG, and 39,000 Btu/h LP) after burningappliance for 15 minutes.2) If required, adjusting the primary air to ensurethat the flame does not carbon. First allowthe unit to burn for 15-20 min. to stabilize.CAUTION: Any alteration to the product thatcauses sooting or carboning that resultsin damage is not the responsibility of themanufacturer.GENERAL SAFETYINFORMATION1) The appliance installation must conform withlocal codes or, in the absence of local codes,with the current Canadian or National GasCodes, CAN1-B149 or ANSI Z223.1Installation Codes.2) See general construction and assemblyinstructions. The appliance and vent shouldbe enclosed.3) This appliance must be connected to thespecified vent and termination cap to the outsideof the building envelope. Never vent to anotherroom or inside a building. Make sure that thevent is fitted as per Venting instructions.4) Inspect the venting system annually for blockageand any signs of deterioration.5) Venting terminals shall not be recessed into awall or siding.6) Any safety glass removed for servicing mustbe replaced prior to operating the appliance.7) To prevent injury, do not allow anyone who isunfamiliar with the operation to use the fireplace.8) Wear gloves and safety glasses for protectionwhile doing required maintenance.9) Be aware of electrical wiring locations in wallsand ceilings when cutting holes for termination.10) Under no circumstances should this appliancebe modified. Parts that have to be removed forservicing should be replaced prior to operatingthis appliance.11) Installation and any repairs to this applianceshould be done by a qualified service person.A professional service person should be calledto inspect this appliance annually. Make it apractice to have all of your gas applianceschecked annually.12) Do not slam shut or strike the glass door.13) Under no circumstances should any solid fuels(wood, paper, cardboard, coal, etc.) be used inthis appliance.14) The appliance area must be kept clear andfree of combustible materials, (gases and otherflammable vapours and liquids).Emissions from burning wood or gas couldcontain chemicals known to the State ofCalifornia to cause cancer, birth defects orother reproductive harm.