Regency ® P121-2/P121LC-2/P121RC-2/P131-2 Zero Clearance Direct Vent Gas Fireplace 31INSTALLATIONINSTALLATIONLOG SET INSTALLATIONRead the instructions below carefully and refer to thediagrams. If logs are broken do not use the unit untilthey are replaced. Broken logs can interfere with thepilot operation.Log Kit # 360-930 contains the following pieces:a) 326 Front Right Logb) 327 Front Left Logc) 328 Middle Right Logd) 329 Middle Left Loge) Embers (902-154)f) Platinum Embers (946-669) - supplied with pack-aged manualThe 3-digit numbers (ie. 327) are molded into the rear of each log.326327329 328Please note that there are 2 of each log.This log set is mirrored front and back.326Push back side of the left end of the log upagainst the tab on the burner.327Grate Post3) Place Log 326 on the front right side of the burner.Ensure that the notches on the far right side of the logfit into the grate posts. Push back side of the left endof the log up against the tab on the burner.Repeat step 3 on the opposite side of the burner.4) Place Log 327 on the front left side of the burner. Po-sition the right end of the log in between the two tabsand the left end of the log into the grate post.Tab on BurnerIMPORTANTWhen placing Embers, do not block burner portsas this can cause an incorrect flame pattern,carbon deposits and delayed ignition.2) Place embers on the burner as shown below.Separate platinum embers and place on the burnerover top of and around embers. Platinum embers cancover burner ports. Avoid stacking platinum embers.1) Carefully remove the logs from the box and unwrapthem. The logs are fragile, handle with care - do notforce into position.326326