Regency ® P121-2/P121LC-2/P121RC-2/P131-2 Zero Clearance Direct Vent Gas Fireplace 11INSTALLATIONLOCATING YOURGAS FIREPLACE1) When selecting a location for your fireplace,ensure that the clearances are met as outlinedin the "Clearances" section.2) Provide adequate clearances for servicing.3) The appliance must be installed on a flat,solid, continuous surface (e.g. wood, metal,concrete). This may be the floor, or raised upon a platform to enhance its visual impact.If the appliance is going to be installed oncarpeting, combustible linoleum tile or othercombustible material other than wood flooring,the appliance must be installed on a metal orwood panel extending the full width and depthof the appliance.4) The Direct Vent Gas Fireplace can be installedas follows:Model # PositionA) P121-2: See ThruB) P131-2: PierC) P121LC-2: Left CornerD) P121RC-2: Right Corner5) This appliance is Listed for bedroominstallations when used with a Listed MillivoltThermostat. Some areas may have furtherrequirements, check local codes beforeinstallation.6) The P121-2/P121LC-2/P121RC-2/P131-2Direct Vent Gas Fireplace is approved for alcoveinstallations, which meet the clearances listedon this page.7) We recommend that you plan your installationon paper using exact measurements forclearances and floor protection before actuallyinstalling this appliance. Have a qualifiedinspector, dealer, or installer review your plansbefore installation.Note: For Exterior Vent TerminationLocations see section "Exterior VentTermination Locations."A) P121-2 See ThruB) P131-2 PierC) P121LC-2 Left CornerD) P121RC-2 Right Corner