Regency P33NG3-R Owners & Installation Manual

Contents

Regency ® P33 Gas Log Fireplace 29CONVERSION KIT #434-967 FROM NG TO ULPGfor P33 using SIT 820 NOVA Gas ValveTHIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER IF IN DOUBT DO NOT DO THIS CONVERSION !!Each ULPG Conversion Kit contains:Qty. Part # Description1 904-529 5/32" Allen Key1 904-575 Burner Orifi ce #551 910-037 LPG Injector (Pilot Orifice)1 918-272 "Converted to ULPG"label1 918-273 Red "ULPG" label1 918-548 Instruction Sheet6) Pull off thepilot cap toexpose thepilot orifice.Remove the 2 screws, push BurnerAssembly to the left and lift out.Installation of ULPG ConversionKit:1) Shut off the gas supply.2) Remove the louvers (and bay door if it isinstalled).3) Open the flush door and remove the door.4) Remove the logs, embers/rockwool.5) Remove the 2 screws holding the BurnerAssembly to the fi rebox base. Push theBurner Assembly to the left and lift out.7) Unscrew the pilot orifice with the allenkey and replace with the LPG pilot orificein the kit and replace pilot cap.8) Remove burner orifice with a 1/2" wrenchand discard. Use another wrench to holdon to the elbow behind the orifice.9) Reinstall new burner orifice ULPGstamped #55 and tighten.10) Turn control knob to the “OFF” position.11) Remove the black protection cap by handfrom the high-low knob (Fig.1).Fig. 112) Insert a 5/32” or 4mm Allen wrenchinto the hexagonal key-way of thescrew (Fig. 2), rotate it counter-clockwise until it is free and extract it.13) Check that the screw is clean and ifnecessary remove dirt.14) Flip the screw (Fig. 3).Fig.2Fig.3Burner Orifice15) Using the Allen wrench as shown inFig.4, rotate the screw clockwise untilsnug, do not overtighten.Fig.4INSTALLATION