Regency P33R-LP2 Owners & Installation Manual

Regency P33R-LP2 Owners & Installation Manual Manual pdf 23 page image

Regency P33R-2 Zero Clearance Rear Vent Direct Vent Gas Fireplace 23Diagram 1Diagram 3STANDARD FLUSHDOORThe standard flush door comes with a blackframe. To install the frame, simply hook the topdoor flange onto the top of the unit and swingthe door towards the unit, diagram 1. Be carefulthat the glass gasket does not roll up; theremust be a gap between the gasket and the doorlip to ensure that the door sits securely on theunit. Diagram 2.Diagram 2INSTALLATION5th Grate Tab6) Place the bottom left front edge of LogD) 02-58 against the left edge of the burnertray and rest the log on the cutout on LogC) 02-60.7) Position Log E) 02-59 across the cutouts inLogs B) 02-61 and C) 02-60. The notch inthe bottom right end fitting against the 5thgrate tab.8) Place the embers on the front of the burnertray in the places shown on the photo.Place embers in these 3 locationson the burner tray.D) 02-58E) 02-59A) 02-57B) 02-61C) 02-60A) 02-57B) 02-61C)102-60D) 02-58C) 02-60A) 02-57B) 02-61C) 02-60B) 02-61E) 02-59Cutout9) Test fire to ensure proper light off (makesure flame flows smoothly from one end ofburner to the other). If there is any flamehesitation, check that area for any block-age of the burner ports.10) Install flush glass and bay glass (if used) asper instructions in this manual.D) 02-58A) 02-57C) 02-60B) 02-61E) 02-59Use the hook to pull the spring out until you canput the hook into the slot on the bottom doorbracket. Repeat for 2nd spring. See diagram 3.To remove the flush door, reverse the abovesteps.Optional Flush TrimAttach the round magnets to the back of the toptrim piece and to the bottom trim piece, thenattach trim to the top and bottom of Flush door.