Regency P33R-LP2 Owners & Installation Manual

Regency P33R-LP2 Owners & Installation Manual Manual pdf 5 page image

Regency P33R-2 Zero Clearance Rear Vent Direct Vent Gas Fireplace 5INSTALLATIONIMPORTANT:SAVE THESEINSTRUCTIONSThe P33R-NG2 or P33R-LP2 Direct Vent Fire-place must be installed in accordance with theseinstructions. Carefully read all the instructions inthis manual first. Consult the "authority havingjurisdiction" to determine the need for a permit priorto starting the installation. It is the responsibility ofthe installer to ensure this fireplace is installed incompliance with manufacturer's instructions andall applicable codes.BEFORE YOU STARTSafe installation and operation of this appliancerequires common sense, however, we arerequired by the Canadian Safety Standardsand ANSI Standards to make you aware of thefollowing:YOUNG CHILDREN SHOULD BECAREFULLY SUPERVISED WHENTHEY ARE IN THE SAME ROOM ASTHE APPLIANCE.CLOTHING OR OTHER FLAMMA-BLE MATERIAL SHOULD NOT BEPLACED ON OR NEAR THE APPLI-ANCE.INSTALLATION AND REPAIRSHOULD BE DONE BY A QUALI-FIED SERVICE PERSON. THE AP-PLIANCE SHOULD BE INSPECTEDBEFORE USE AND AT LEAST AN-NUALLY BY A PROFESSIONALSERVICE PERSON. MORE FRE-QUENT CLEANING MAY BE RE-QUIRED DUE TO EXCESSIVE LINTFROM CARPETING, BEDDING MA-TERIAL, ETC. IT IS IMPERATIVETHAT CONTROL COMPART-MENTS, BURNERS AND CIRCULAT-ING AIR PASSAGEWAYS OF THEAPPLIANCE BE KEPT CLEAN.DUE TO HIGH TEMPERATURES,THE APPLIANCE SHOULD BE LO-CATED OUT OF TRAFFIC ANDAWAY FROM FURNITURE ANDDRAPERIES.WARNING: FAILURE TO INSTALLTHIS APPLIANCE CORRECTLYWILL VOID YOUR WARRANTY ANDMAY CAUSE A SERIOUS HOUSEFIRE.CHILDREN AND ADULTS SHOULDBE ALERTED TO THE HAZARDSOF HIGH SURFACE TEMPERA-TURES, ESPECIALLY THE FIRE-PLACE GLASS, AND SHOULDSTAY AWAY TO AVOID BURNS ORCLOTHING IGNITION.GENERAL SAFETYINFORMATION1) The appliance installation must conformwith local codes or, in the absence of localcodes, with the current Canadian orNational Gas Codes, CAN1-B149 orANSI Z223.1 Installation Codes.2) The appliance when installed, must beelectrically grounded in accordance withlocal codes, or in the absence of localcodes with the current National ElectricalCode, ANSI/NFPA 70 or CSA C22.1 Cana-dian Electrical Code.3) See general construction and assemblyinstructions. The appliance and vent shouldbe enclosed.4) This appliance must be connected to thespecified vent and termination cap to theoutside of the building envelope. Nevervent to another room or inside a building.Make sure that the vent is fitted as perVenting instructions.5) Inspect the venting system annually forblockage and any signs of deterioration.6) Venting terminals shall not be recessed into a wallor siding.7) Any safety glass removed for servicingmust be replaced prior to operating theappliance.8) To prevent injury, do not allow anyone whois unfamiliar with the operation to use thefireplace.9) Wear gloves and safety glasses for pro-tection while doing required maintenance.10) Be aware of electrical wiring locations inwalls and ceilings when cutting holes fortermination.11) Under no circumstances should this appli-ance be modified. Parts that have to beremoved for servicing should be replacedprior to operating this appliance.12) Installation and any repairs to this appli-ance should be done by a qualified serviceperson. A professional service personshould be called to inspect this applianceannually. Make it a practice to have all ofyour gas appliances checked annually.13) Do not slam shut or strike the glass door.14) Under no circumstances should any solidfuels (wood, paper, cardboard, coal, etc.)be used in this appliance.15) The appliance area must be kept clear andfree of combustible materials, (gases andother flammable vapours and liquids).MANUFACTUREDMOBILE HOMEADDITIONALREQUIREMENTS1) Ensure that structural members are not cutor weakened during installation.2) Ensure proper grounding using the #8ground lug provided. See page 26.Emissions from burning wood or gas couldcontain chemicals known to the State ofCalifornia to cause cancer, birth defects orother reproductive harm.