Regency P33R-LP2 Owners & Installation Manual

Regency P33R-LP2 Owners & Installation Manual Manual pdf 31 page image

Regency P33R-2 Zero Clearance Rear Vent Direct Vent Gas Fireplace 31MAINTENANCETHERMOPILE/THERMOCOUPLE1) Open the bottom louvers.2) Loosen the thermocouple or thermopile witha 7/16" wrench.3) Disconnect thermocouple by loosening nutfrom the valve with a 9mm wrench. Discon-nect thermopile by loosening 2 screwsmarked TP on the valve.4) Drop the thermocouple or thermopile downfrom the bracket and pull it out of the unit.5) Reinstall the new ones in reverse order.GLASS GASKETIf the glass gasket requires replacement use5/8" flat glass gasket for the Bay Front (Part #936-243) and a tadpole glass gasket for theFlush Front (Part # 936-155).DOOR GLASSYour Regency stove is supplied with hightemperature, 5 mm Neoceram ceramic glassthat will withstand the highest heat that yourunit will produce. If your glass requirescleaning, we recommend using an approvedglass cleaner available at all authorized deal-ers. Do not use abrasive materials. Do not cleanthe glass when hot.In the event that you break your glass by impact,purchase your replacement from an authorizedRegency dealer only, and follow our step-by-step instructions for replacement.Flush Glass ReplacementRemove the flush door front (as per instructionson page 23). Remove the 4 glass clips from eachcorner. Slide in the new replacement glass.Push the 4 glass clips back onto the frame. Theglass must have gasketing around it.Bay Glass Replacement1) Remove the door from the unit and place ona soft surface to prevent scratching.2) Remove the nuts holding the glass clips inplace and remove.3) Replace the glass. The glass must havegasketing around it.5) Reverse the previous steps, replace theglass clips and fasten with the nuts but donot over tighten, as this can break the glass.6) Replace door on the stove and check theseal.WARNING: Do not operate theappliance with the glass panelsremoved, cracked or broken. Re-placement of the glass panelsshould be done by a licensed orqualified service person.Caution: Wear gloves when remov-ing damaged or broken glass.