Regency P33R-LP2 Owners & Installation Manual

Regency P33R-LP2 Owners & Installation Manual Manual pdf 25 page image

Regency P33R-2 Zero Clearance Rear Vent Direct Vent Gas Fireplace 25INSTALLATIONOPTIONALWALL THERMOSTATA wall thermostat may be installed if desired,connect the wires as per the wiring diagram.Use table below to determine the maximum wirelength.Note: Preferable if the thermostat is in-stalled on an interior wall.Regency offers an optional programmable ther-mostat but any 250-750 millivolt rated non-anticipator type thermostat that is CSA, ULC orUL approved may be used.CAUTIONDo not wire millivoltwall thermostat wiresto 120V wire.14 GA.16 GA.18 GA.20 GA.22 GA.50 Ft.32 Ft.20 Ft.12 Ft.9 Ft.Recommended Maximum Lead Length(Two-Wire) When Using WallThermostat (CP-2 System)Wire Size Max. LengthThermostat Wire Table5) Open the bottom louver. Pull the Burner ON/OFF control box from inside the bottom of thefireplace and position the slots in the bracketover the 2 screws on the left side of thebottom louver. Push down to lock into place.Tighten the screws.Burner ON/OFFcontrol boxScrews on louverbracketBAY LOUVERS1) Install top louver by sliding the two bracketclips into the brackets located on top of thebay door. See below. The fitted louverleaves a small gap between faceplate bot-tom and louver top.2) Install bottom louver by sliding the twobracket clips into the brackets located un-derneath the bay door. Secure with 1 screwinto each Bottom Louver Mounting Bracketas per diagram below. Use the bottom holein the bracket.3) Slide the valve extension knobs onto thevalve knobs. Match the correct ext. knobwith the valve knob.OPTIONALREMOTE CONTROLUse the Regency Remote Control Kit approvedfor this unit. Use of other systems may voidyour warranty.The remote control kit comes with a hand heldtransmitter, a receiver and a wall mountingplate.1) Choose a convenient location on the wallto install the receiver and the receptaclebox (protection from extreme heat is veryimportant). Run wires from the fireplace tothat location. Use Thermostat Wire Table.2) Connect the two wires to the gas valve.See diagram below.CAUTIONDo not wire millivoltremote control wiresto 120V wire.3) Install 3 AAA alkaline batteries in transmit-ter and 4 AA alkaline batteries in thereceiver. Install the receiver and its coverin the wall. Switch the remote receiver to"remote" mode. The remote control is nowready for operation.OPTIONALWALL SWITCH1) Run the supplied 15' of wire through theright or left side gas inlet opening. Becareful not to damage wire.Note: We recommend a maximum of 15'of wire but if you wish to go witha longer run, use the ThermostatWire Table.2) Connect the wire to the supplied wallswitch and install into the receptacle box.CAUTIONDo not wire millivoltwall switch wireto 120V wire.