10 FPI P36-4 Zero Clearance Direct Vent Gas FireplaceINSTALLATIONHEATWAVEDUCT SYSTEMOPTIONAL KIT #946-556The HeatWave Air Duct Kit increases theeffectiveness of your fireplace by dispersingwarm air from the fireplace to remote locations inthe same room or other rooms in your home.Up to two kits may be installed on thefireplace.Please Note: Only 1 HeatWave kit may beoperated at one time. This includes the internalblower option as well.Diagram 1This includes:1) Clocking the appliance to ensure the correctfiring rate (rate noted on label 30,000 Btu/h)after burning appliance for 15 minutes.2) If required, adjusting the primary air toensure that the flame does not carbon.First allow the unit to burn for 15-20 min.to stabilize.CAUTION:Any alteration to the product that causessooting or carboning that results indamage is not the responsibility of themanufacturer.LOCATING YOURGAS FIREPLACE1) When selecting a location for your fireplace,ensure that the clearances outlined on thispage are met.2) Provide adequate clearances forservicing.3) The appliance must be installed on a flat,solid, continuous surface (e.g. wood, metal,concrete). This may be the floor, or raised upon a platform to enhance its visual impact.If the appliance is going to be installedon carpeting, combustible linoleum tile orother combustible material other than woodflooring, the appliance must be installed ona metal or wood panel extending the fullwidth and depth of the appliance.4) The P36 Direct Vent Gas Fireplace can beinstalled in a recessed position or framedout into the room as in A, B, C, D. SeeDiagram 1.Note: For vent terminations see the" E x t e r i o r Ve n t Te r m i n a t i o nLocations" section.MANUFACTUREDMOBILE HOMEADDITIONALREQUIREMENTS1) Ensure that structural members are not cutor weakened during installation.2) Ensure proper grounding using the #8ground lug provided. See the "AlternateWiring Diagram for Wall Switch" section.5) This appliance is Listed for bedroominstallations when used with a Listed MillivoltThermostat. Some areas may have furtherrequirements, check local codes beforeinstallation.6) The P36 Direct Vent Gas Fireplace isapproved for alcove installations, whichmeet the clearances listed on this page.7) We recommend that you plan your installationon paper using exact measurements forclearances and floor protection beforeactually installing this appliance. Have aqualified inspector, dealer, or installer reviewyour plans before installation.A) Flat on WallB) Flat on Wall CornerC) Recessed into Wall/AlcoveD) CornerBefore leaving this unit with the customer,the installer must ensure that the appliance isfiring correctly and operation fully explainedto customer.OPTIONALHEAT RELEASE KIT#946-570The Heat Release Kit expels warm air fromthe fireplace to the outside of the building,allowing the fireplace to be operated with lessheat entering the room. The kit may be used oneither the left or right side.The HeatWave Duct Kit has differentclearance and framing requirements, checkthe HeatWave manual for details.