Regency P36D-NG1 Owners & Installation Manual

Also see for P36D-1: Owners & installation manual

Contents

Regency P36D-NG1 Owners & Installation Manual Manual pdf 6 page image

6 Regency ® P36D-1 Zero Clearance Direct Vent Gas FireplaceSAFETY LABELThis is a copy of the label that accompanies each P36D-1 Zero Clearance Direct Vent Gas Fireplace. We have printed a copy of the contents here for yourreview. The safety label is located on the front inside base of the unit, visible when the bottom louver is open.NOTE: FPI units are constantly being improved. Check the label on the unit and if there is a difference, the label on the unit is the correct one.COPY OF SAFETY DECAL FOR P36D-1DO NOT REMOVE THIS LABEL / NE PAS ENLEVER CETTE ÉTIQUETTE306306DOOR SEAL: Pleasecheck that the door isproperly sealedMinimum Clearances to Combustibles /Degagement Minimum De Materiaux CombustiblesSerial No./ No de serie918-500aThe "Bay Louvers" beused with the Bay Glass optionMUSTMAY BE INSTALLED IN MANUFACTURED (MOBILE) HOMES AFTER FIRST SALE.Duplicate S/NB B32"CeilingWallWall A(See Instruction Manual fordetailed instructions)Electrical supply / Électrique 115VAC, 1.13 A, 60Hz.VENTED GAS FIREPLACE HEATER -NOT FOR USE WITH SOLID FUELS.NE PAS UTILISER AVEC DU COMBUSTIBLE SOLIDE.FOYER AU GAZ À ÉVACUATION -This appliance must be installed in accordance with local codes, if any; if none, follow the National Fuel Gas Code, ANSI Z223.1, or Natural Gas and Propane Installation Code, CSA B149.1.This appliance must be installed in accordance with the Standard CAN/CSA Z240 MH, Mobile Housing, in Canada, or with the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280, in the UnitedStates, or when such a standard is not applicable, ANSI/NCSBCS A225.1/NFPA 501A, Manufactured Home Installations Standard or ANSI A119.2 ou NFPA 501C Standard for Recreational VehiclesThis appliance is only for use with the type of gas indicated on the rating plate and may be installed in an aftermarket, permanently located, manufactured (mobile) home where not prohibited by local codes. See owner's manualfor details.Installer l'appareil selon les codes ou règlements locaux, ou, en l'absence de tels règlements, selon les codes d'installation ANSI Z223.1, National Fuel Gas Code ou CSA-B149.1 en vigueur.Installer l'appareil selon la norme CAN/CSA-Z240, Série MM, Maison mobiles ou CAN/CSA-Z240 VC, Véhicules de camping, ou la norme 24 CFR Part 3280, Manufactured Home Construction and Safety Standard. Si cesnormes ne sont pas pertinentes, utilisez la norme ANSI/NCSBCS A225.1/NFPA 501A, Manufactured Home Installations Standard, ou ANSI A119.2 ou NFPA 501C Standard for Recreational Vehicles.For use with glass doors certified with the appliance onlyThis vented gas fireplace heater is not for use with air filters. Ne pas utiliser de filtre à air avec ce foyer au gaz à évacuation.Fan (Part # 432-917) Optional Bay Window (Part #510-930) Option: HeatWave Kit # 946-556Cet appareil doit être utilize uniquement avec le type de gaz indiqué sur la plaque signalétique. Cet appareil peut être installé dans une maison préfabriquée ou mobile (É.-U. seulement) installée à demeure si les règlementslocaux le permettent. Voir la notice de l'utilisateur pour plus de renseignements. Cet appareil ne peut pas être utilisé avec d'autres gaz sauf si une trousse de conversion certifiée est fournie.Pour utilisation uniquement avec les portes en verre certifiées avec l'appareil Made in Canada/Fabrique au CanadaFPI Fireplace Products International Ltd.Delta, BC, CanadaListed:Certified for/Certifi e pour:Tested to:WN# 16462CANADA and U.S.A.CGA-2-17-M91, ANSI Z21.88a-2007 / CSA 2.33a-2007VENTED GAS FIREPLACE HEATER / FOYER AU GAZ À ÉVACUATIONéAPPAREIL FONCTIONNANT AU GAZ PROPANECONCU POUR ETRE POELE:Pression d'allimentation minimumPression à la tubulure d' chappement lev ePression à la tubulure d' chappement basseGrandeur de l'injecteurD bit minimum selonD bit maximum selonl'altitudeCalorifiqueCalorifiqueModéle P36D-LP1é é ééééNATURAL GAS:Minimum supply pressureManifold pressure highManifold pressure lowOrifice sizeMinimum inputMaximum inputAltitudeModel P36D-NG1LPROPANE:Minimum supply pressureManifold pressure highManifold pressure lowOrifice sizeMinimum inputMaximum inputAltitudeModel P36D-LP1L5" WC(1.25 kPa)3.8" WC(0.95 kPa)1.1" WC(0.27 kPa)# 37 DMS15,500 Btu/h (4.54 kW)0-4500 ft/pi(0-1372 m)30,000 Btu/h (8.79 kW)12" WC(3.00 kPa)11" WC(2.74 kPa)2.9" WC(0.72 kPa)# 52 DMS15,000 Btu/h (3.96 kW)0-4500 ft/pi(0-1372 m)30,000 Btu/h (7.91 kW)APPAREIL FONCTIONNANT AU NATURAL GAZCONCU POUR ETRE POELE:Pression d'allimentation minimumPression à la tubulure d' chappement lev ePression à la tubulure d' chappement basseGrandeur de l'injecteurD bit minimum selonD bit maximum selonl'altitudeCalorifiqueCalorifiqueModéle P36D-NG1é é ééééModel/Modele:P36D-NG1Model/Modele:P36D-LP10" Clearance tocombustibles from:Mantel Clearances from Top:Side Wall Clearancefrom Side FacingAlcove Clearances:Minimum Vent Clearances:Top, sides, bottom and rear of unit(A) Min. 7" (177mm)B) 6" with Flush or Bay FrontB) 8" with Barcelona TrimAlcove approved forBay & Flush Louvers.Max. Depth 36" (914mm)Min. Width 48" (1219mm),Min. Height 72" (1229mm)Horizontal Top 2-1/2" (64mm)Horizontal SideHorizontal Bottom 1-1/2" (38mm)1-1/2" (38mm)For the State of Massachusetts, installationand repair must be done by a plumber orgasfitter licensed in the Commonwealth ofMassachusetts.For the State of Massachusetts, flexibleconnectors shall not exceed 36 inches inlength.For the State of Massachusetts, the appli-ances individual manual shut-off must be at-handle type valve.The State of Massachusetts requires theinstallation of a carbon monoxide alarm inaccordance with NFPA 720 and a CO alarmwith battery back up in the same room wherethe gas appliance is installed.