Saeco CAP001/A Instruction And Maintenance Manual

Contents

English106 - USING THE MACHINEImportantBefore operating the machine it is necessary to have read thispublication carefully and to have gained a good generalknowledge of the machine.After a period of inactivity of the machine it is advisable toread again chapter “5.3 before re-utilising the machine.6.1 Machine statusesConcerning the electricity mains, the machine can be found in oneof the following statuses:Machine off and cut out- Main switch (ref. 10, fig. 1) and all-pole switch in position“0“ or plug disconnected.- Only the stored data memory is active.Machine on- Main switch (ref. 10, fig. 1) and all-pole switch in position “I“or plug connected.- All functions are active and display (ref. 8a, fig. 1) is on.Standby mode (machine off but not cut out)- Main switch (ref. 10, fig. 1) in position “I“.- Functions “AUTOMATIC OPERATION”, “ANTIFREEZ-ING”, are active if selected, and “CLOCK”, as well as thedisplay and stored data memory.- Diplay backlighting is off.6.2 Manual switching onThis type of starting up is required when the machine is in the“machine off and cut out” status (see 6.1 Machine statuses). It isnecessary to proceed as described in “5.3 First switching on” bydisconnecting the dispensed drink command, if possible.6.3 Programmed automatic switchingonIt is possible when the machine is in “STANDBY” mode and thefunction “AUTOMATIC OPERATION” is activeThe machine will switch on at the preset time.6.4 Temporary switching on fromstandbyIt is a manual and voluntary start, controlled by the User with themachine in “STANDBY” mode.It is obtained by pressing key for 3 seconds.The machine will revert automatically to the “STANDBY” mode60 minutes after the last operation performed.6.5 Coffee dispensingBriefly press (less than 1 sec.):- key to obtain a single small cup, the display will show “1SMALL CUP”;or- key to obtain two small cups (a double dose of cof-fee is used), the display will show “2 SMALL CUPS”;or- key to obtain a single large cup, the display will show “1LARGE CUP”;or- key to obtain two large cups (a double dose of cof-fee is used), the display will show “2 LARGE CUPS”.All these types of dispensing are obtained from coffee that is in-stantly ground by the machine.During the dispensing, the display will show “PREINFUSION”,if enabled by menu (see “6.14 Menu-programmable functions”);beside the message, an icon with a cup being filled will be dis-played.When the dispensing is over the display will show “READY FORUSE”.6.6 Pre-ground coffee dispensingUse pre-ground coffee instantly loaded into the machine for pre-ground coffee dispensing.- Briefly press (less than 1 sec.) key once. The display willshow “PRE-GROUND”.- Use the specific measuring spoon to introduce one dose ofpre-ground coffee through the pre-ground coffee slot (ref. 6,fig. 1).- Press key or .The machine will behave as for a normal dispensing, utilisingthe dose of pre-ground coffee manually introduced.N.B.: Dispensing with pre-ground coffee is programmable onlyfor one dose.