Salus AX10RF System Manual
Also see for SS881ZB: Quick install guideInstallation and quick start guide
                                                                     | |
Contents
| 
6 1AWRT10RF Pairing without InternetConnection (AC10RF Coordinator)Section 6System Configuration without internet connectionPrior to using the AC10RF Coordinator on a system with no internet connection, update thefirmware version as follows:1 Use a computer with an internet connection that meets the following requirements:2 Go to the SALUS Software Tools web page: www.salusinc.com/tools.html3 Download and run the Coordinator Update Tool to update the AC10RF Coordinator byfollowing the onscreen instructions4 Insert the AC10RF Coordinator into a USB port on the computer when prompted to do soAfter updating the firmware, insert the AC10RF Coordinator into the provided power adapter andplug the two devices into an AC outlet Verify that the LED is solid redPairing with AKL01/04/06PRF and AKL08RF Relay ControllersBefore pairing, the AKL Series Relay Controller and optional AX10RF Receiver (if desired) must beinstalled and powered in accordance with installation instructions included with these devices• The Network Status LED on the AKL Relay controller should be flashing and,• if an AX10RF Receiver is used, the LED backlight on the Auto/Manual switch of this deviceshould be flashing redStep 1. Press and hold the lighted red button on the AC10RF Coordinator for 5 seconds until theLED begins flashing, to begin pairing When the network status LED on the AKL Wiring Center andthe backlight on the Auto/Manual switch of the AX10RF (if used) stop flashing, they have joined thenetwork and you are ready to pair the AWRT Wireless Radiant ThermostatCOMPUTER PC MacOPERATING SYSTEM Windows 8 or later OSX 10.10 or laterUSB PORT Type A Type AIf the network status LED on the AKL Wiring Center continues blinking, turn off the power tothe device for 10 seconds. |
Related manuals for Salus SS881ZB
manualsdatabase
Your AI-powered manual search engine