Wiring the Mains Power Supply Plug (UK Only)IMPORTANT NOTICEThe mains lead on this equipment is supplied with a moulded plug incorporating a fuse. The value of the fuse isindicated on the pin face of the plug and, if it requires replacing, a fuse approved to BSI1362 of the same rating mustbe used.Never use the plug with the fuse cover omitted if the cover is detachable. If a replacement fuse cover is required, itmust be of the same colour as the pin face of the plug. Replacement covers are available from your dealer.If the fitted plug is not suitable for the power points in your house or the cable is not long enough to reach a powerpoint, you should obtain a suitably approved extension lead or consult your de aler for assistance. However, if there isno alternative but to cut off the plug, remove the fuse and then safely dispose of the plug.Do NOT connect the plug to a mains socket as there is a risk of shock hazard from the bared flexible cord.IMPORTANTThe wires in the mains lead are coloured in accordance with the following code:BLUE - NEUTRAL BROWN - LIVEAs these colours may not correspond to the coloured markings identifying the terminals in your plug, proceed asfollows : The wire coloured BLUE must be connected to the terminal marked with the letter N or coloured BLUE orBLACK. The wire coloured BROWN must be connected to the terminal marked with the letter L or coloured BROWN orRED.WARNINGDO NOT CONNECT EITHER WIRE TO THE EARTH TERMINAL, WHICH IS MARKED WITH THE LETTER E OR BY THE EARTHSYMBOL, OR COLOURED GREEN OR GREEN AND YELLOW.