Samsung 500 Series User Manual

Also see for OFFICESERV 500 Series: Service manual System administration guide Quick setup guide Quick setup guide Quick setup guide

Contents

17English03 Basic FeaturesPixel Shift (Off / On): Using this function, you canminutely move pixels on the PDP in horizontal or verticaldirection to minimize after-images on the screen.✎ Optimum condition for pixel shiftItem TV/AV/Component/HDMI/PCHorizontal 0~4 4Vertical 0~4 4Time (minute) 1~4 min. 4 min.✎ The Pixel Shift value may differ depending on theTV size (inches) and mode.✎ This function is not available in the Screen Fitmode.Auto Protection Time (10 min. / 20 min. / 40 min. /1 hour / Off): Set the time the screen remains idle with astill image until the screen saver is activated. The ScreenSaver prevents the formation of ghost images on thescreen.Scrolling: This function removes after-images on thescreen by moving all the pixels on the PDP accordingto a pattern. Use this function when there are remainingafter-images or symbols on the screen, especially whenyou displayed a still image on the screen for a long time.✎ The after-image removal function has to beexecuted for a long time (approximately 1 hour)to effectively remove after-images on the screen.If the after-image is not removed after performingthe function, repeat the function again.✎ Press any key on the remote control to cancel thisfeature.Side Gray (Light / Dark): When you watch TV with thescreen ratio set to 4:3, the screen is prevented from anydamage by adjusting the white balance on both extremeleft and right sides.Picture Reset (OK / Cancel)Resets your current picture mode to its default settings.¦ Setting up the TV with Your PCSet the input source to PC.O MENUm → Picture → ENTEREAuto Adjustment tAdjust frequency values/positions and ine tune the settingsautomatically.✎ Not available when connecting with an HDMI/DVI cable.Screen■ Coarse / Fine: Removes or reduces picture noise. If thenoise is not removed by Fine-tuning alone, then adjustthe frequency as best as possible (Coarse) and Fine-tune again. After the noise has been reduced, readjustthe picture so that it is aligned to the center of screen.■ Position: Adjust the PC’s screen positioning if it doesnot it the TV screen. Press the ▲ or ▼ button to adjustthe Vertical-Position. Press the ◄ or ► button to adjustthe Horizontal-Position.■ Image Reset: Resets the image to default settings.Using Your TV as a Computer (PC) DisplaySetting Up Your PC Software (Based on Windows XP)Depending on the version of Windows and the video card,the actual screens on your PC will probably look different, butthe same basic set-up information will apply in most cases.(If not, contact your computer manufacturer or SamsungDealer.)1. Click on “Control Panel” on the Windows start menu.2. Click on “Appearance and Themes” in the “ControlPanel” window and a display dialog-box will appear.3. Click on “Display” and a display dialog box will appear.4. Navigate to the “Settings” tab on the display dialog-box.y The correct size setting (resolution) [Optimum: 1920 X1080 pixels]y If a vertical-frequency option exists on your displaysettings dialog box, the correct value is “60” or “60 Hz”.Otherwise, just click “OK” and exit the dialog box.