English - 118Network Settings and InfoLinkNetwork Connection - CableLAN Connection for a DHCP EnvironmentThe procedures to set up the network using Dynamic Host Configuration Protocol (DHCP) are described below. Since anIP address, subnet mask, gateway, and DNS are automatically allocated when DHCP is selected, you do not have to enterthem manually.TV Rear PanelThe Modem Porton the WallModem Cable2External Modem(ADSL/VDSL/Cable TV) LANCable11. Connect the[LAN] port onthe rear panel ofthe TV and theexternal modemwith a LAN Cable.2. Connect the LANport on the walland the externalmodem with aModem Cable.TV Rear PanelThe Modem Porton the WallExternal Modem(ADSL/VDSL/Cable TV)IP SharerLAN CableModem CableTV Rear PanelLAN CableYou can connect the LAN port and the TV directly depending on your network status.The LAN Porton the WallYou can connect the LAN via a Sharer (Router).LAN CableThe terminals (the position of the port and the type) of the external device may differ depending on the manufacturer.If the IP address allocation by the DHCP server has failed, turn the external modem off, turn it on again after at least 10seconds and then try again.For the connections between the external modem and the Sharer (Router), refer to the owner’s manual of thecorresponding product.You can connect the TV to the LAN directly without connecting it through a Sharer (Router)You cannot use a manual-connection-type ADSL modem because it does not support DHCP. You have to use anautomatic-connection-type ADSL modem.➣➣➣➣➣To access Samsung’s Infolink network feature, you must make one of the connections on the following pages.
