Regulatory information1325. Appendix• Consult the dealer or experienced radio TV technician for help.Change or modifications not expressly approved by the manufacturerresponsible for compliance could void the user's authority to operate theequipment.Canadian radio interference regulationsThis digital apparatus does not exceed the Class B limits for radio noiseemissions from digital apparatus as set out in the interference-causingequipment standard entitled “Digital Apparatus”, ICES-003 of the Industry andScience Canada.Cet appareil numérique respecte les limites de bruits radioélectriquesapplicables aux appareils numériques de Classe B prescrites dans la norme sur lematériel brouilleur: “Appareils Numériques”, ICES-003 édictée par l’Industrie etSciences Canada.15United States of AmericaFederal Communications Commission (FCC)Intentional emitter per FCC Part 15Low power, Radio LAN devices (radio frequency (RF) wireless communicationdevices), operating in the 2.4 GHz/5 GHz Band, may be present (embedded) inyour printer system. This section is only applicable if these devices are present.Refer to the system label to verify the presence of wireless devices.Wireless devices that may be in your system are only qualified for use in theUnited States of America if an FCC ID number is on the system label.The FCC has set a general guideline of 20 cm (8 inches) separation between thedevice and the body, for use of a wireless device near the body (this does notinclude extremities). This device should be used more than 20 cm (8 inches)from the body when wireless devices are on. The power output of the wirelessdevice (or devices), which may be embedded in your printer, is well below theRF exposure limits as set by the FCC.This transmitter must not be collocated or operation in conjunction with anyother antenna or transmitter.Operation of this device is subject to the following two conditions: (1) Thisdevice may not cause harmful interference, and (2) this device must accept anyinterference received, including interference that may cause undesiredoperation of the device.
